0
Can anyone tell me why my 1974 Corvette won't fire even after I've replaced the plugs and wires the condensor the rotor and distributor cap and the condensor?
Wiki User
∙ 17y ago
On a 74 Corvette, there is a primary coil inside of the distributor that is usually the cause. I would assume that the engine turns over, but no fire. While you have the distributor apart, you might as well replace the secondary coil, located under the distributor plate too, because if this is the problem, you would have to tear the whole thing down again to fix it, and the parts do not cost that much.
Wiki User
∙ 17y ago
Add your answer:
Earn +20 pts
Does anyone have a diagram of a distributor cap for a 2000 Chevy 2.2L 4 cylinder?
It doesn't have a distributor cap.
Does anyone have a vacuum tube diagram for a 1985 5.7L Tuned Port Injection Corvette Engine?
Does anyone have a diagram for the Vacuum connections for a 1985 5.7 L Tune Port Injection Corvette engine?
Has anyone heard of how to do an intake conversion on a 1984 corvette and what else would need to be done Some say I'd have to change the distributor the transmission because they run off of the CPU?
Well if you really want to go balls out, bypass the CPU & everything it enteracts with.
How do you recharge the condensor?
hire a EPA certified HVAC technician. federal law requires anyone handling refrigerants to be EPA certified.
When my 95 geo prism stalled on the road i replaced the distributor coil and the fuel filter then after that my car started shaking on the freeway at 3 thousand rpm whats going on can anyone help?
check your time and fuel injecters
Anyone know what would cause a 95 civic to be really sluggish just replaced the distributor and plugs it takes me 100 yards to hit 30mph?
probably have the wires mixed up that would be the first thing i would check
Did eminem die and get replaced?
No,Eminem is alive and never got replaced by anyone.
1974 pickup 390 mtr has been converted to electronic ignition The ignition fried Replaced ignition and coil Ignition switch is good but still no spark Can anyone help?
You'd have to describe the components you replaced. Did you use a plug and go all in one distributor or did you replace the coil, distributor, and add an electronic ignition unit? If you "fried" your ignition, it's likely you fried something else along the line too. Check all your components.
Has anyone had any problems with a 1980 Ca Corvette with computer carb I have a check engine light that comes on after 1600 rpm indicating a lean condition have replaced O sensor had ECM changed etc.?
Hmm, I had a similar problem.. Mine turned out to be the egr valve..
Where is the igniter on a 1993 Honda Accord lx?
Igniter? Please elaborate as I am not familiar with the term ignitor on a gasoline engine, and do not understand what you are referring to. Within the oem distributor, there is an oem electrical ignitor($70). It is a very common issue and problem with 93 honda accords... it can be replaced and the rest of the oem distributor is useable and salvaged, so dont throw it away! or listen to anyone that says the car is not getting spark and that the entire distributor is bad or the coil is bad, only replace with an aftermarket ignitor/distributor as a last option.
No fire replaced ballast resistor plugs wires dist cap rotor coil ign module voltage regulator does anyone know what else it could be 1973 duster 8-cylinder?
Is the rotor bug turning when the distributor cap is off when you turn it over?, if not the gear on the bottom of the distributor could have come off or your timing chain could be broke.
Where can one purchase a 2008 Corvette?
Vette Finders lets you search and find listed Corvettes for sell. Additionally, Craigslist would be useful to see if anyone is selling a 2008 Corvette in the classifieds.
