metholated spirits is a WOOD ALCHOL,it will absorb WATERand is ideal to remove moisture from fuel systems if not overused,ie a pint in the tank eg but there are good AFTER MARKET PRODUCTS to clean fuel systems particularly good for fuel injector systems, but if injectors have not been occaisionally treated then they may need removing to service properly g.d.
make sure your computer is unplugged and remove the fan from inside, and thoroughly clean it. this will "lessen" or remove the windy noise.
You probably need to clean the splines. Remove the rear tires, and pop loose the nut at the hub, and remove it, and clean out the rust best you can and grease it up really well. Should solve your problem.
CLEAN power is power that is free from noise.
Clean.
Transmission or transfer case? If fliud levels are correct and clean and noise is continual remove and fix. No other way around it.
Ensure your Soldiers wear earplugs, do not remove inserts from aircraft helmets, avoid unnecessary exposure, limit necessary exposure to short periods of time, and clean hearing protectors
No, it is for noise only.
Check the idle air control valve (IAC valve). If dirty clean or replace. Also check air/smog pump. Be sure intake fins on that are clean. Even if clean, could be causing the noise.
There is a free program called Audacity which, though it has a weak point at file types, is very good for recording and refining. Once you have installed Audacity, select a section of pure noise. Then go into the Effect menu. Select "Noise Removal". Click "Get Noise Profile", select the entire area you want noise removed from, go into "Noise Removal" again, and click "Remove Noise".
The most common cause of noise in your AM radio is a loose or corroded ground wire. Clean and tighten the ground wire and the AM noise should disappear.
The cable needs lubricating. Remove the speedometer cable and lubricating it with special lube for that purpose. Any auto parts store can provide the proper lube. Remove the cable and clean it throughly with spray brake cleaner. Let it dry and apply the lube. Reinstall the cable and you should see the needle stop jumping and making noise.
To remove snot/mucus from the noise, usually by blowing into it. (: