Depending on the year and make and engine size, some systems have 60 to 66 psi in that fuel line and adding a hose with clamps is not a good idea.
name 4 clamps used for metal fabrication industry?
You have to remove the clamps then the hose. You have to replace the clamps because you will ruin them when you take them off. Be careful if you're taking off the pump. You may have to remove the pulley to get access to the high pressure line. The metal lines and rubber tubes must be tight against the block. The vibration will wear a hole faster than a fox in a forest fire. The headaches with finding a new metal line are overwhelming. Cadi really blew that design.
Metal not rubber
Rub my metal balls or rubber balls.
Rubber is not an element. Natural rubber has organic origin, from the sap of a tree.
Those cars usually have a metal line the rots out just bypass the rusted/rotten metal with a piece of rubber hose and clamps Keep away from the serp belt
yes, you can buy metal rubber at your local wal-mart
if its high pressure no you will need the metal lines with the high compression fittings. hope this helps
Every welder ought to have many clamps! C-clamps, vice grips, wide mouth vice grips (snap clamps) and bar clamps; a nice dead blow (metal mallet covered in rubber,) wire brush to clean welding area before and after weld, good grinder to grind down a finished weld. Also setup blocks, but that's only in R&D and precision welding shops.
The high pressure hose will have a metal fitting that you will need a wrench to remove whereas the return side will have hose clamps - below are several video tutorials that will help .
what kind of "pipe"? solid metal pipe, or flexible rubber "pipe"? number one cause is from aged rubber that dries out and cracks. loose hose clamps, wore a hole through it, cracked thermostat housing, etc.
why are metal prongs of a plug sealed in plastic and rubber
New connection, the pieces have a male and female end that fits together and is sealed with packing and molten lead. if a repair is made in the middle of a run you can use a repair coupling that is a rubber sleeve held in place with hose clamps. They are either just the rubber sleeve or they can have a metal outer covering to protect the rubber.
It is that property in which a metal can be extended or shaped by beating with a hammer or by the pressure of rollers. Metals become more malleable when heated.
rubber is an inorganic substance
Rubbery Metal its metal and rubber CHECK IT OUT!!!
Mostly metal, sometimes plastic and sometimes rubber+metal or rubber+plastic. Sometimes all 3.
metal is a conductor and rubber is an insulator.
metal is a conductor and rubber is an insulator
The tire is predominantly rubber, which is non-metal.
Metal and rubber