You will need to sand the floor to give the thinset something to stick to.
yes
Yes, concrete is porous and water will move through it over time.
Yes there are certain kinds of epoxies that can be applied over SOME sealed floors. It depends on what type of sealer was used first. They tend to not bond well with some solvent sealers, but water based ones will work. You just have to use the right epoxy primer so it will bond
I spoke to the one paint dealer I have confidence in and was told yes I can do exactly that i.e. put a latex (not sure about alkyd) two part epoxy coating over my concrete latex floor paint. First I sanded the surface to get a better bond and my next move is to clean the floor. As a suggestion be sure you have a concrete paint on the floor. If not you could have other problems which I encountered originally i.e. paint not adherring to the concrete in the presence of water. USE ARMORGUARD EPOXY FLOOR COATING, It will last forever, its 100% Solid, No fillers, ODORLESS and NON TOXIC, Its also made with MICROBAN to prevent mold, mildew or algae, look on www.ecosmartepoxysystems.com for more information
No, parquet has been known to buckle because he moisture in the cement has nowhere to escape too.
Absolutely.
yes
no
Normaly this is not repaired. Just floor over it.
Concrete needed for concrete floor 15' x 22' x 5" will be 7.63 cubic yards if your grading is pefect - Remember to add a bit more (always better to have some left over than to come up short)
Tile is an insulator. If the tile is placed correctly over an existing wood floor and is sealed with grout, it will insulate the room it is in.
Over time they may, but if it's a relatively new floor, it shouldn't.
Yes, concrete is porous and water will move through it over time.
Bathroom lighting is installed the same as any other lighting fixture would be. The only difference is they are sealed off so moisture cannot ruin the electrical wiring.
Yes there are certain kinds of epoxies that can be applied over SOME sealed floors. It depends on what type of sealer was used first. They tend to not bond well with some solvent sealers, but water based ones will work. You just have to use the right epoxy primer so it will bond
Well first of all there is no such thing as a fiberglass pool. You can have fiberglass walls instead of steel but your pool is still vinyl because you need a liner. These are the usual combinations of inground pools. Sand floor, steel walls, vinyl liner Sand floor, fiberglass walls, vinyl liner Vermiculite floor, steel walls, vinyl liner Vermiculite floor, fiberglass walls, vinyl liner Concrete floor, steel walls, vinyl liner Concrete floor, fiberglass walls, vinyl liner Concrete floor, concrete walls, no liner Concrete pools have to be painted with epoxy paint or if you want tile installed then usually you plaster over the concrete. Now a days 3 and 4 are the most common inground installs. 1 and 2 are usually pools that are 30 + years old although you can still have them done that way. In South Alabama the cost of a 20 *40 vinyl pool will cost around 18 to 22 thousand
You don't put padding directly on a concrete floor. You have to frame out the floor, lay plywood sheets over the frame, probably want a vapor barrier as well. Then you can lay any pad and carpet you want. There are certain types of carpet that come with an attached foam padding that are designed to lay over concrete. If you think you want to just glue carpet directly to the concrete floor, check the mfg. warranty first. Most mfgs. will not honor their warranty unless they specifically state that it can be glued to concrete.