0
Can wheel speed sensor be removed from the hub on 2000 Montana?
Electronicspark
No, replace the entire hub.
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
Where are the wheel rotation speed sensors for the ABS and TRAC systems on a 2003 Pontiac Montana?
It is on front/rear hub assy - bearing, studs and wheel speed sensor
How do you change a rear wheel bearing on a 2000 Pontiac Montana?
You need to replace the rear wheel hub - bearing and speed sensor inclusive
How do you Replace front wheel studs on 2000 Montana?
You replace the wheel bearing hub assembly - it has studs, bearings and wheel speed sensor around $100 part
Why is the trac off and emergency brake light not going off after Istart driving my 2000 Pontiac Montana?
You need a wheel speed sensor! Wheel speed sensor is a part of wheel hub assembly with bearing, studs and sensor. You have four wheel speed sensors, one in each wheel. One or more of them are bad or the wiring or connector. If you check it with a ABS capable OBDII scanner it will let you know which wheel signal has the problem.
How do you replace a speed sensor on a 2004 Acura TL?
Need to know if you are asking about the vehicle speed sensor, a front wheel speed sensor or rear wheel speed sensor.
Where is the speed sensor on a 2004 Chrysler sebring touring edition?
There are two speed sensors on the front of the transmission and one abs wheel speed sensor at each wheel bearing.There are two speed sensors on the front of the transmission and one abs wheel speed sensor at each wheel bearing.
Where is the wheel speed sensor located?
Wheel speed or ABS sensor's are located on the suspension Knuckle Front and Rear.
Where is the vehicle speed sensor located on a 99 ram?
The vehicle speed sensor is the sensor on top of the rear axle. If the vehicle has 4 wheel ABS then there will be a speed sensor on each front wheel.
Where wheel speed sensor on an olds intrigue?
there is none. the speed sensor is in the tranny
How do you replace a wheel assembly on a 2000 Montana with out cutting the abs wires?
You need to remove the hub assembly and replace it. It consists of bearing, studs and speed sensor. The wires are attached to a connector which is clipped to sensor shield. You cannot remove sensor on Montana without removing the hub. The sensor is a part of assembly.
What is a wheel speed sensor?
It is a sensor that monitors wheel speed and sends that info to the abs module and/or the traction control module.
Where is the speed sensor location on a 1998 ford Windstar?
If the speed sensor is for an Anti-lock braking issue, you will normally find 1 at each wheel (accessible when the wheel is removed). Another location would be on the transmission. How about where on the transmission? Like on the bottom behind the exhaust pipe!
