? why ? diagnose and repair is your best bet... everyone should have a manual for their vehicle, and the library should have a professional shop manual available in the REFERENCE section...make copies of the right sections...good luck :)
The crankshaft position sensor is required and can not be bypassed.
No I don't think so.
No, if you do you will have no power steering. You could not steer this vehicle with the power steering pump bypassed.
Most likely the new pulley is not in line with the rest.
NoNo
You will need to buy and install an ac bypass pulley from Napa or other parts store to bypass the ac compressor.You will need to buy and install an ac bypass pulley from Napa or other parts store to bypass the ac compressor.
You can not. The crankshaft position sensor is required to run the engine.
Since they don't list this part at any of the online stores, I would suggest removeing the hose & it's clamps, bring it all to the parts store, then have them make the best suggestion on what to purchase. Bring the new stuff home, and put it on where you removed the original. go to a parts story and ask for a bypass for the type of car it is for.
Discard the valve all together and plug the vacuum line as if there was no bypass valve
to bypass the computer, u need to change the carburettor, the distributer the coil and if its automatic, u need to change the transmission
Depending on the placement of the leak, the tube could be patched or bypassed. It the tube is rubber then the bad spot can be cut out and replaced. If it is a metal tube then it will either have to be bypassed by running a hose past it to connect to the connections at the ends, or replacing the hose with a new replacement.
You can't. The engine's control unit needs it to differentiate between spark and fuel injection events.