Yes, it is possible to convert a manual into an automatic. I converted my automatic integra into a manual. It runs smooth as silk. To tell you the truth and not to discurage you, it would be easier to sell your manual or even trade it for somebodys automatic. There are many Integra lovers that would love to get their hands on a manual. If this is not possible here it goes. It will be even more expensive to convert to an automatic than it is to convert to a manual.Why? There are more electoronic components involved versus the manual.(sensors, shift lock, ect.) These are the parts: 1: Automatic transmission with sensors 2: torque converter and plate 3: automatic mid shaft(manual's is different) 4: shift cable 5: automatic pedal set (brake and gas) 6: automatic shifter complete with interlock switch and harness 7: automatic cluster 8: automatic ecu 9: automatic flywheel cover 10: rear transmission bracket and the lower transmission bracket( the manual ones is different ( trust me I know) You will also need the top transmission mount and the top transmission frame bracket that you can purchase at Acura for about $50. You will have to cut the manual off the frame, grind the welds down and weld the auto bracket in place. 11: You will need a wheel saw to cut away at the center console where the manual shifter is. you need to make room for the manual shifter and the shift cable 12: The center shift console needs to be changed as well. The manual one is smaller. 13: You need the auto flywheel plate bolts, the manual one are longer. 14: you need the automatic starter as well. 15: you need the automatic radiator, the manual one does not have the tranny oil cooler in it. 16: The only other thing brother is the electrical. You need to run two wires to the shift lock, the reverse wires to the auto shifter, the cruise controll to the auto shifter and you should be set and ready to cruise. Now the only thing left is for who to do the install?
it will fit but you need to convert it to a cable clutch because the 98's are hydraulic
Yes you can convert an auto to a stick you need a hydo-trans out of a 94-2000 integra,99-00 civic is or any type R trans.You have to take the dash off you also need to by the shift linkege. As far as the peddel you just have to hang it.for more detail call 5135333456 or 5138742508.
Converting a manual transmission to automatic transmission is not possible but you can replace a manual transmission to an automativ transmission . That is also an expensive deal.
how much you got??????????????
Purchase a vehicle with an automatic transmission.
with modifications and a mounting kit, and a way to convert cable clutch pedal to operate the hydraulic clutch transmissionhasport.com
You must be kidding!!! Sell this car and buy an automatic.
Yes, a 2004 Mazda 6 can be converted from an automatic transmission to a manual transmission. However, it is very time consuming and will cost a lot of money to do this.
Why the hell would you want to?
Sure! But it would probably be cheaper to buy another car.
I am assuming that this is the question, how do I convert a manual 540 to automatic? The answer is easy as I want to convert my automatic 540 to manual so we swap parts. firstname.lastname@example.org
If it's an automatic, most likely a Turbo 350.
Yes, with much difficulty and a donor car with all the parts necessary. Sell this car and buy a manual.
Yes, by removing the manual transmission and installing an automatic. Unless you have a donor car this would be extremely expensive. My advice is that if you want an A/T sell the car you have and then buy one with an automatic.
You sell the automatic and by one with a manual transmission. It's too expensive and too time consuming to swap them.
Yes, you need to get a top loader transmission and linkage
yea but its a pain. better off finding a stick car
It depends on the transmission type. For a 4-speed automatic transmission (4F27E) needs a torque converter, but for a 6-speed PowerShift needs no torque converter at all, it using the Dual Clutch technology.
The highest cc scooter is a 1000cc scooter. It is the 1000cc Moto Guzzi convert with an automatic transmission scooter.
Best choice would be a TH700-R4
It is impossible to 'convert' an automatic transmission into a manual transmission. You car replace the automatic with a manual, which also requires installing a clutch pedal, clutch cable, or clutch master and slave cylinders, as well as a shifter and shift linkages. Check at local junkyards for a car about the same year, make, and model as the one that you have which has a manual transmission, remove, or have removed, this transmission, including the clutch and bell housing, and install these in your car.
Sure. Purchasing a doner truck that is automatic for parts would be the way to go.
Yes you can. It is expensive and needs quite a bit of part switching from the transmission to the clutch, stick, but can be done.
You cannot convert an automatic transmission to a manual one, but you can replace the automatic with a manual. It is a big job and if you do not do it your self would probably cost a lot more than selling the automatic truck and buying a manual truck. The manual will require different shift linkage, adding clutch pedal and parts to actuate the clutch, and you may need a drive shaft of different length. It is also common for automatics and manuals to use different rear axle ratios, and even the Electrinic Control Module and some wiring may need to be changed. Maybe that automatic is not so bad after all.