If it is the correct O/D you can.
Cut the pipe and remove it, fix pipe with a coupling.
As of July 2014, the market cap for Northwest Pipe Company (NWPX) is $355,728,584.97.
Cut the end of the cap off, about 1/2 inch back from the end and then cut the side of the cap. You should be able to peel the cap off of the pipe. If you have enough pipe, just cut the entire cap off and start with a clean section.
The death cap is more poisonous than the snakes bite. It depends what kind of snake it is.
if it's plastic pipe you can just buy a glue cap and glue it on. If it's galvanized or cast iron pipe you can use a gym cap, (arubber cap that comes with a hose clamp). Just put that on the pipe and tighten it down firmly. this will prevent any sewer gas from coming out of the drain.
There is a threaded pipe coming out of the right side engine block. It extends out and has a hex pipe cap on the pipe. Just unscrew the cap and it will drain.
On the right rear of the tractor above and to the right of the PTO shaft. Looks like a piece of pipe with a pipe cap and vent on top.
1/2 inch for 1/2 inch pipe.
when you want to make these COOL things you need to make some holes in a pipe and put an end cap on it and walla you have yourself a PVC pipe Flute
If it is capped tight, it is no longer in use and that keeps rain and birds out of the pipe. If it has a cap that is above the pipe like an umbrella, it is for the same reason and to let fumes or exhaust out.
when you want to make these COOL things you need to make some holes in a pipe and put an end cap on it and walla you have yourself a PVC pipe flute
Either to cap a pipe going to an existing fixture, or to put a T in the line for furture use. A stub, as if you cut off a finger and left a stub. It is the end of the pipe.