Cut the end of the cap off, about 1/2 inch back from the end and then cut the side of the cap. You should be able to peel the cap off of the pipe. If you have enough pipe, just cut the entire cap off and start with a clean section.
There are multiple reasons to get your drain pipe inspected. One major reason to inspect a drain pipe is before buying a house to make sure everything runs correctly.
You cant, you have to remove the section of piping and install a new section of piping.
You need at least a 3 in. pipe -- shower is 2 in. pipe
Mission CAP or IPS plug if there is a female fitting
Remove the bottom hose to drain the system. Remove the top one as well and flush from the top with a brisk flow from a hose pipe.
The toilet flange is usually above the floor level. You would have to cut it off the drain pipe and cap it. How you do this depends on what type of pipe the drain is made of. Even if the drain should be below the floor level, you have to seal the drain or sewer gas will come up from the drain.
You can drain it directly into a drain pipe. Just make sure the the top of the drain pipe is even with the top of the washing machine. If not, the water from the washing machine will drain all of the time. There is no valve in the machine to stop the water from draining. The washing machine drains using a pump motor.
another clog, further down the drain pipe. You need a drain snake.
You need to check for a clogged pipe .
It's not the toilet, there's a blockage in the pipes some where after the drain pipe from the toilet joins up with the drain pipe from the tub.You're going to need to have the pipe snaked.
There should be a nut around the chrome pipe holding it to the brass. Loosen the nut and pull the chrome pipe out.
a 3 inch pipe