You can drill a hole in anything as long as you have a strong enough drill bit and drill. But why would you want to drill holes in your exhaust? The exhaust piping is there to route exhaust gases away from underneath the car so they don't pool up underneath your car and seep into the cabin and cause a variety of health problems.
Yes! Then you would have triple exhaust.
3 hole drill press `
You use a diamond core tile drill which is the appropriate size to the diameter you need. Common drill sizes for tiles are 6mm and 8mm for rawl plugs. For service pipes they are 16mm 30mm and 40mm. These will cover radiator pipes, waste pipes, shower head and other hole sizes. To stop the diamond core hole saw or drill bit from slipping you need a guide plate to hold it steady on the tile.
You can drill a hole in the side of anything with the right drill.
There are many different types of exhaust pipes all with different reliabilities. The best type would be stainless steal exhaust pipes which do not rust and therefore last the longest. They are however the most expensive.
In the exhaust pipes under the truck. In the exhaust pipes under the truck.
you can cut a hole in wood using a special drill attachment. alternatively you could drill a hole then cut a hole with a jigsaw
It collects the exhaust gasses and directs them to the pipes.
dual exhaust
Yes they do
yes, if the trans fluid is hitting the exhaust, but not out of the pipes coming from the outside of the pipes.
A core drill is a drill specifically designed to remove a cylinder of material, much like a hole saw. The material left inside the drill bit is referred to as the core. Diamond core bit is commonly used in construction to create holes for pipes, manholes, and other large-diameter penetrations in concrete or stone.