0
Can you fit a 350 Chevy engine in a 1993 cavalier and if so what modifications need to be made?
Wiki User
∙ 15y ago
This would be an almost impossible swap. Not saying it is not possible, but almost impossible. First off there is not enough room for a 350 in the engine bay. Secondly the Cavalier is FWD. It would be impossible to drive the front wheels off a V8. You would have to convert the Cavalier to RWD to even make this remotely feasible. Thirdly is the weight issue of the V8. IMO, this would be an impossible swap or would mean that so may modifications would be required as to make this way too costly.
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
Where is the knock sensor for a 93 cavalier located?
The knock sensor for the 1993 Chevy Cavalier is located in the back of the motor. It can also be located in the engine valve.
How do you replace the fuel filter located on a 1993 Chevy Cavalier?
i need to find location of fuel filter on 1993 Chevy cavalier
1993 cavalier vl spark plug gap?
1993 Chevy cavalier 2.2l Spark gap is....................... 1.4mm
How do you override a Governor on a 1993 Chevy Cavalier?
What governor?
Where is the oil filter located on a 1993 Chevy Cavalier?
It's in the rear of the engine not the front. It's hard to see but it's tucked up there.
Where is the neutral safety switch on a 1993 Chevy cavalier?
The neutral safety switch, on your 1993 Chevy Cavalier, is located beneath the shifting column. The switch can be accessed by removing the shifting boot.
Why does Water drip under 1993 Chevy Cavalier?
Because your fail
How do you check the check engine light codes for a 1993 Chevy cavalier?
you can take it to auto zone or advance auto parts stores, and they will put the scanner on it for free.
Where is fuel filter located on 1993 Chevy Cavalier?
Behind the gas tank.
Does a 1993 Chevy cavalier z24 have a timing chain or belt?
Timing chain.
How much does a 1993 Chevy Cavalier station wagon cost?
$15,000 .00
You Have a 1993 Chevy Cavalier 2.2 Engine and the Number 1 and 4 cylinders are not firing you replaced the coil but their still not firing any ideas?
your control module is bad
