The Dodge Intrepid has front and rear brake hoses
Inside the trunk there is a turnable thumb screws where the brake lights are. Twist screws off and the brake light pops out.
yes it can and it should be done every 30000 miles or 2 years
Remove caliper, pull rotor off hub, push new one on.
The 1999 Dodge intrepid brake lines schematics diagram shows the routing of each brake line. The diagram will show the brake line routing from the master cylinder to each wheel.
Resevoir against firewall at driver's side
DOT 3 or DOT 4
If the brake lights stay on when the car is not running on most vehicles, including the 1994 Dodge Intrepid, there is probably a short somewhere in the wiring to the brake lights. The first place to investigate this problem would be the wires along the firewall that control the brake lights. Also, check the brake light switch above the brake pedal.
Bulb, wire, fuse, etc.
Failed line, seal, hose, caliper, etc.
common metric socket set, brake fluid, brake pads, some of that brake quiet crap auto zone always give you, heavy duty flat head.... a jack, and a little know how, and time
Check for a blown brake light fuse. Check for a broken or out of adjustment brake light switch.
you either don't have the brake fully dis-engaged or you need to have your brakes checked for wear.
how do i change to front brakes on a dodge durango?
how do change brake pads on a 2002 dodge pickup 4x4
Pop the trunk, remove the "3 wingnuts" behind or on the carpet. That will in turn loosen the tail lights. Turn the bulb, and voila!
On driver side under dash, just straight up the emergency brake in a block box
Yellow cap, under the hood, driver side, near the base of the windshield.
Remove the cowel,wiper blades and wiper motor remove master cylinder only and move off the side ,do not unhook brake lines or bend or kink them from under the dash remove the arm that hooks to the brake pedel and 4 brake booster bolts and wa-la its out
Defective or out of adjustment brake light switch, if the switch is mounted on the brake lever. If the switch is on the master cylinder, then it needs replacing.
It might be a dodge intrepid. The 1967 Dodge Charger had one long tail/brake light .
If you can find a rim that bolts up and fits over the brake caliper, then yes.
Brake Light switch works without the ignition on. unplug the brake pedal switch and check to see if the brake lights are still on..switch could be defective