Want this question answered?
No it does not. Just hook it up it will work
An electrical leaf blower may be easier to use than a gas blower for a small woman because of the start-up of the machine. With a gas blower it may be difficult at times to start the motor, simply because there are steps you must take that may require a little muscle in order to start it up. With electric blower all you have to do is hook up an extension cord, plug it in and turn it on.
1. Remove the instrument panel and pad. 2. Remove the right side ventilator duct. 3.Disconnect the blower motor connector. 4. Push the flange holding hook toward the blower motor, then rotate the blower motor clockwise and remove it from the A/C unit assembly. 5. Installation is the reverse of removal, noting the following: 6. Rotate the blower motor until the blower motor flange holding hook locks securely in A/C unit assembly.
It means there's something wrong in the blower circuit, maybe a bad motor. Hook it directly to the battery to find out.
There should be a vacuum port on the back of the intake, behind the carburetor. It has to have vacuum on it at all times.
It hooks up to the vacuum ports on the carb or intake.
Worms wiggle when you try to put them on the hook. I saw a small insect wiggle under a leaf
If you remove the small panel below the glove box and look up you will see wires comming from the blower motor and going to a small unit that sits in the air duct box. It is held in with 2 screw bolts and the wires can be followed to the blower motor where they will plug into it. Easy access can be obtained by dropping the glove box out of the way by sliding the stopper hook to the side. Very easy fix if you are having any problem with fan speeds not working.
It does not hook to the intake. It fits on the big vacuum port on the back of the carburetor.
There will be a hole in the valley pan under the intake manifold. This takes a rubber grommet that the PCV goes into. Then the hose runs to either the large port on the carb, or there should also be a port in the intake runner that it can hook to.
A palatal hook is a small hook for attaching elastic bands on the internal side of braces, or a term used in typography for a hacek.
engine vacuum or direct into the intake.