0
no, because it has integral tail lamps in the roof and the seatbelts arent connected to the top
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
How do you take top off of a ford bronco xlt?
Remove the interior trim along the rear windows and between the cab and fiberglass roof. Take out all the bolts that you expose. Slide the roof back slightly then lift it and set it down somewhere safe.
If the top on a 1988 Ford Bronco can be removed how do you remove it?
yes , top can be removed. remove trim along bottom sides of top, also remove trim where front of top meets roof of cab then remove bolts that hold top to vehicle. then with some buddies, lift top off
Can you take oil pan off 1989 bronco without removing the engine from the vehicle?
how to remove oil pan from 1989 bronco 2
Should you remove snow and ice from your roof or allow it to melt off?
No, take it off your roof. It will pool up water come spring, and might dent your roof.
What years do ford broncos' top come off?
The Bronco's design was intended to have the top come off so every year bronco's top can come off but they only make soft tops up to 77 for the bronco so before you try to take yours off think about getting a custom made one or the seal of the roof wont be the same.
How do you remove the roof racks off of a dodge magnum?
you will probably have to take the headliner down to get to the nuts that hold the rack to the roof.
Can I remove my own snow from my roof?
It is safe do to so depending on how much snow there is. Start off with standing on a ladder and shoveling it off of the roof. Get as far up as you can and then you can slowly ease your way onto the roof.
How do you remove the roof on a 1994 Corvette?
you get a hack saw and cut it off or get an alluminion blade to saw it off
Is there an alternative to a roofrake to remove ice?
first we need to know where you want to remove the ice from-- and lets not forget -- the roof rake is meant for pulling snow off the roof not ice
Can you remove the roof off of a 1994 bronco and how do you do it?
Yes you can remove the rear fiberglass roof (although it can be dangerous in a roll over). All you do is remove the trim around the rear top. After you remove the trim remove the bolts that go all the way around the top (you're gonna need a special torx bit since the bolts are the tamper-proof kind). After you remove the bolts you have to lift the top up and back away from the cab at the same time. There are guide poles that stick down about an inch from the rear bottom edges of the top, so be careful you dont break them off. You will also have to remove the plug for the rear break light on the top. It's by the rear driver's side corner. Also remember to unbolt the rear shoulder belts that are mounted to the roof on 92-96 models. The top is pretty heavy (about 180 pounds) so get somebody to help you with it. It's pretty bulky so it helps to have someone else to help you balance it. Be sure to set the top on something, not just the floor, so you won't damage the bottom edges or else it might not seal back properly when (or if) you put it back on. Step by step directions can be found in a Haynes (or other company's) Auto Repair Manual for an 80-96 Ford F-Series/Bronco which you can buy at any good local auto shop for around 20 bucks. These also have lots of other helpful information for minor (and major) repairs you might do. Note- removing the top off of a Ford Bronco 1992 or newer renders the car illegal for street driving because of the third tail light and shoulder seat-belts mounted on the roof. It's okay if you have a 1991 or older Bronco, or just drive off-road with the top off, but Ford never intended the roof to come off of the newer Broncos on-road.
Can you remove an high top off an 1995 Chevy van?
No. They cut out the original roof, and place the fiberglass in place over the hole. You could remove if you welded on a new roof panel.
How do you get the hub off the axle of a full size 1995 ford bronco in order to remove the rotor?
You have to have a spanner wrench. One you have that, remove the safety ring, use your spanner wrench, and it comes right off.
