answersLogoWhite

0


Best Answer

Yes u can.

User Avatar

Wiki User

12y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Can you over tighten the screws on a battery terminal?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you reset the check engine light on a 2001 Kia Optima?

Remove the positive terminal on the battery for 20-30 minutes and then replace the terminal on the battery and tighten the bolt very well. Also, for battery acid build-up on the terminals, pour several cups of boiling water over the battery terminals.


Why does a battery terminal corrode?

The battery acid is leaking out, either do to a failing battery or do to an alternator that is over charging.


Can grease be used to prevent corrosion on a car battery terminal battery?

A very thin smear of Copper Grease over the Battery terminal / Cable end will help pevent corrosion.


How to Install a New Car Battery?

Install a New Car BatteryInstalling a battery for your car is a very easy task that can be done with a few simple tools. Anybody with a little mechanical knowledge can perform the task.Battery Placement and SecurityBegin by placing your battery carefully onto the battery platform. Make sure the platform is clean of debris so that the battery sits level. Then take the battery bracket, which is used to hold the battery in place, and tighten it down using a socket wrench. Now that the battery is securely held in place, be sure to check that you have everything else in place before connecting the battery.Connecting The BatteryBefore connecting the battery, it's a good idea to place a protective rubber casing over the connection so that it sits between the battery cable and the battery casing. This will prevent any corrosion of the casing to occur. Start with the positive battery cable. Place it over the terminal connection until it is all the way down and the terminal is sticking out above the terminal. Tighten the cable securely to the terminal with a wrench. Repeat the same procedure with the negative battery cable and you will be good to go.


What is the problem when you get sparks at the positive terminal of the battery when you try to start your tractor though the starter does not turn over and the tractor does not start?

you have a dirty battery post


Is the distributor on a 1999 Chevy Astro van 6-cylinder a sealed unit or does it have a replaceable cap?

It is replaceable. Two screws hold it on. Try and find an AC Delco OEM replacement. I had problems with after market ones. Also, be careful not to over tighten the screws when putting on the new one. The tabs with the holes in it can break off if you over tighten.


How do you change battery on Citroen C4?

There is a cover that is over the battery on a Citroen C4 that will have to be removed to expose the battery. There are several screws that will need removed and then the cover lifts right off. Remove the battery connections and lift the battery out.


How do you change starter on ranger 2002?

Jack and support front or use ramps to elevate front of vehicle. Disconnect the negative battery terminal. Remove electrical connections and then the mounting bolts, be careful, the starter is very heavy. Align and install mounting bolts, then reconnect electrical connectors, and reinstall negative battery cable. It might be a good time to disconnect the positive battery terminal as well, use a terminal cleaner to clean the battery terminals, the insides of the clamps, then spread dielectric grease over terminal, reconnect all and snug.


How do you reconnect the battery on a 1995 Pontiac grand prix se?

1. Loosen the clamp nut till the clamp easily fits over the appropriate terminal. (Red for positive, black for neg. Usually the battery will have a + (pos) and (-Neg) mark on the top. Make sure to clean the terminal, before you try to put the wire on it. That will make sure there is a good connection between the battery and the electrical system.) 2. Push the cable clamp all the way onto the terminal post. Then properly tighten the clamp around the post. If it sparks a little when you connect the second post don't panic. Complete the process. When you connect the battery you will hear the alarm go off. Yup, That's normal and should quit in a minute. all systems go through a syncronization but that should be it . Congrats!


How do you reset your Nintendo DS to factory settings?

Reset Factory Settings for Nintendo DS1. Take the Battery out and wait 45 seconds or longer and then reinstall the battery. 2. Turn the DS over and remove the small screws holding the battery access cover3. Remove the battery


What is battery terminal grease?

A grease-like material that keeps H20 from soaking into your battery! People usually use petroleum jelly rather than grease because it does not harden with time. It prevents water coming into contact with the different metal components preventing electrolysis which, in time, will degrade the terminal and allow the build up of salts preventing a decent connection. It is smeared over the terminal of the battery and the connector before they are brought together - this helps ensure that there are no metal parts exposed to the moisture in the air...


Why will your 96 Tahoe not start if the battery and starter are good?

Do you mean it won't start or it won't turn the engine over? Possibly poor contacts, check battery cable, also ground cables. If you have a sidepost battery, Remove the battery cables and check the center bolt that screws into the battery. These have a history of corroding and are easy to replace.