0
Can you plug an amplifier in to an LCD TV via the headphone port on the LCD. will it blow. i have a jvc amplifier with two Bose speakers i want to use them on the LCD?
Wiki User
∙ 14y ago
Plug the audio system into the AUDIO OUTPUT jacks on the LCD. Go into the menu and change the signal to the jacks to FIXED if you can.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Will 20W speakers work with a 10W amplifier?
They'll work, but could blow.
Do Bose car speakers blow out a lot?
They probably don't blow out anymore than any other speakers. It all depends on how you take care of them and how much wear and tear you put into them.
Is it possible to blow sol republic headphone speakers?
Yes, i had mine for about a week and after listening to bass heavy music at full blast i think they just gave out
85 Corvette has speakers in the dashon top how to remove?
FIRST VERIFY THAT THERE ARE REALLY SPEAKERS THERE, MINE JUST HAS GRILL AND NO SPEAKERS, I BELIEVE BOSE SYSTEM DOES NOT HAVE SPEAKERS THERE. IF YOU DID WANT TO GET TO THEM, YOU WOULD NEED TO REMOVE ALMOST THE WHOLE DASH TO GET TO THEM. MY GRILLS WERE NOT REMOVABLE FROM THE TOP. I HAVE REMOVED THE WHOLE DASH DOWN TO THAT POINT. DONT DO IT. IT WILL BLOW YOUR MIND HOW MUCH YOU HAVE TO REMOVE TO GET THERE. That is correct. No dashboard speakers on Bose System. Billy
Can you blow out your speakers if you use the wrong power amplifier?
Speakers can be blown if the wrong power amplifier is used and damage can be done by either overpowering or underpowering the amp. For example, if the power rating of the speaker is 300 watts capacity you will need a 300- to 600-watt amp.
Can you run 4 70w speakers on a 150w amp or will it blow?
It's entirely possible to use four 70W speakers with a 150W amplifier but the method will depend on the speakers and the amplifier specification. We will assume that the amplifier will deliver up to 150W per channel, so two speakers will be used on each channel. If the amplifier is rated to drive a 4 ohm load, then two 8 ohm speakers can be wired in parallel and connected. In this instance, take care NOT to drive the amplifier too hard. It will overdrive the speakers at about the same time that it will begin to show a distorted output. This is a condition that can easily damage speakers so be very conservative with the volume control. If the speakers are 4 ohm speakers, they can be wired in series to provide a total impedance of 8 ohms. If the amplifier is rated to deliver 150W into 4 ohms, then the total power to the speakers will be lower than to a single speaker. The benefit is that no speaker can be over-driven and there is a good amount of headroom for safety.
When was Blow Your Speakers created?
Blow Your Speakers was created in 1987.
Can you play a bass guitar through a tube amplifier?
Years ago all we had was tube amplifiers. As long as its a bass amp (so you don't blow out the speakers) there is no problem.
What is the best way to wire your subs to get the most power?
You get more power by wiring the speakers in parallel, but you need to verify that the amplifier can handle that configuration or you may blow the amp.
What if you used 240V UK supply to power 120V US Bose speakers?
Don't do it. Period. You will overheat the wires , blow the board and start a fire within seconds. I assume you're talking about the pre amp and the amplifier. Most sound systems run their own power supplies to the speakers. Do this instead. Check the Bose speakers and see if they have a voltage differential switch, some do especially if you're in Europe or the UK. If they do not and you are in the UK you will need to get a transformer to step down the voltage to 120V 60 hertz. Be sure to match the amperage of your system to the transformer you get. My personal advice is not to use the speakers at all as the price of the transformer and the hum that it produces compromises the benefit you might derive from the sound system.
How to turn headphone mode off on iPhones?
Blow compressed air into the jack (headphone socket)
Will my 2 speakers both 140W blow with a 450W amplifier?
Yes, most likely. If your speakers are rated for 140w each then it's possible to blow them if your amp drives em at full power. If you do hook them up then find a way to limit the volume or output of your amp. Sophisticated amps and stereos have settings that allow you to do this.
