0
Can you put a C-6 trans bolted to a Ford racing small block 302 mounted in a 1966 2 2 Mustang?
Wiki User
∙ 16y ago
yes, a small block C6. out of a rancharow. Thoes had a 302 C6 . not a big block C6 . and a custom drive shaft. that dont cost to much. !!good luck!!
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
Were is oil pump in 1990 mustang?
Inside the oil pan mounted on the engine block.
Where is the crank position senor on 97 Mazda b2300?
It is mounted on the front of the block at the crankshaft. It is bolted on the driver's side of the engine.
Where is the PVC valve located at on a 1993 Mustang?
5.0L-The valve is located on top of the block by the firewall 2.3L-The valve is mounted inline with the breather hose
Where is the crank sensor located on a 2001 dodge ram van?
GAS ENGINE The sensor is mounted on the bellhousing DIESEL ENGINE Bolted to the left rear side of the engine block
How long has ken block been racing rally cars?
Ken Block has started racing in 2005.
Where is the oil pan on a 2007 Saturn Ion?
Mounted on the bottom of the engine block.Mounted on the bottom of the engine block.
Where are vortec heads?
Mounted on top of the block.
Where are the freeze plugs on a 1995 Mustang?
in the engine block
Where is the block on a 2013 f-350 6.7 diesel?
Can't see much of the block because everything is bolted to it or inside it.
Where is the ecm located on a dodge ram 3500 year 2000 truck?
The ECM is located on the drivers side of the engine block. It is mounted behind the fuel filter housing. It is bolted to the engine block behind the fuel filter. Remove the fuel filter mounting bolts and it will fall out of the way giving access to the ecm. The ecm wiring connector is bolted to the ecm with one bolt, going through the middle of the connector. It is a 4 mm allen bolt.
Will a 2004 mustang transmission with a 302 block in a 1968 mustang?
no an 04 mustang is a 4.6 dohc and a 68 302 is a 5.0 sohc not even close
Where is the Block heater in a 1991 mustang 5.0 lx?
There is not a block heater on this car. My 1991 Ford Mustang 5.0 LX had a block heater but I can't remember where it was installed on the engine , I believe on the passenger side of the engine block in a freeze plug ( expansion plug ) hole
