0
No you cannot. Big block parts are all different then small block parts. The distributor cap WILL WORK. That answer is incorrect. Big Block and small block Chevrolet distributors physically interchange with no problem (unless it's a tall deck block like a 502)
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
Does a 77 350 have point?
Not unless someone put a breaker point's distributor in it. It had an HEI / HIGH ENERGY IGNITION distributor in it from the factory.
Will a 454 interchange with a 350?
it should, i just put a 350 in a truck that had a 454 in it previously. mated 2 a 400 turbo tran
Can you put a 454 transmission on a 350 engine?
yes you can its the same tranny
Can you put a 454 engine with a Turbo 350 transmission?
Yes but the transmission will blow you need a racing 350 transmission
What cOIL should you put for a 350 chevy engine with a HEI mallory distributor?
Stick with the coil recommended by Mallory.
Can you take the water pump off a 350 Chevy and put it on a 454 Chevy big block?
NO it will not work.
Can you put a 454 or 350 in a 93 Crown Victoria?
While anything is possible with enough money and determination, the practical answer in this case is NO.
What motor wll fit the 84 Chevy c10?
I'm not sure how much bigger than a 454 you can put in it, but a 350 will definitely fit in it, as I'm sure you already know, along with the 454.
I have a 1970 el camino. should i rebuilt a 350 engine that needs a lot of work or replace it with a 454 engine?
both good engines but i have 65 elcamio with a 454 and it is just the best engine i have ever put into a chev. i would go with a 454
Could you put a Chevrolet 454 engine in an 1970 Chevrolet Impala with a 350 engine?
Yes. You'll need to change the exhaust and cooling systems.
Can i put Hei in a 351w Ford?
Yes, there are a few different companies that make a drop in HEI distributor for ford engines. Procomp Electronics, crt performance, and ignition plus all make them. These are on the lower end, there are also some higher end companies.
I put corvette heads and a cam and new pistons on a 350 it start but when you put in D it shuts off?
Check your compression, crankshaft timing and ignition timing (crankshaft timing first THEN ignition timing)
