You should extract bolt instead of drilling and re-threading.
A tap is a tool, a tap can cut or clean the threads of a bolt hole, there are differant diameters and thread pitch, a dye is the opposite of a tap it cuts or cleans the threads of a bolt.
The tool for cutting internal threads is called a tap. A tool for cutting external threads is called a die.
Assuming you mean "thread tap", it is for cutting new threads in a hole.
A rethread kit cleans up damaged existing threads. A tap and die kit makes threads from scratch.
They are used for putting threads on screws / bolts or, for putting threads in holes. Taps put threads in holes. You can actually get a combined drill and tap. I have added a link under related source so you can see what they look like
A. Tap
drill it out using a left handed drill bit. if you screw the threads up re tap the hole using a tap from a tap and die set if its still screwed up go to your local auto parts store and tell them they will hook you up
A thread chaser is used to clean and restore damaged or dirty threads vs. a tap or, die which cuts threads.
They are used for putting threads on screws / bolts or, for putting threads in holes. Taps put threads in holes. You can actually get a combined drill and tap. I have added a link under related source so you can see what they look like
Taps and dies are used to thread . A tap threads a hole and a die threads a rod.
is when you re-cut the threads in a bore using a die tool that is struck and then turned to make the threads