0
Better known as a smog pump. Check with state inspections if they require emision testing. As far as if it will hurt the motor, No it will not, an the increase in horse power is really not significant.Most problems are with the gulp valve or diverter valve which causes back fire when throttling back. Air pump failure is due to carbon siezure from check valves on exaust.
Wiki User
∙ 10y ago
Add your answer:
Earn +20 pts
How do you bled air from power steering pump on 99 Chevy 350?
It should be self-purging, unless there is some sort of leak.
How does the polution air pump system work on a Chevy p30 with a 350 engine?
The AIR pump, pumps clean air into the burnt exhaust gasses that is in the exhaust system/pipes and cleans it up before it exits the tail pipe.
How can you tell if the smog pump is defective on a 1979 Chevy pick up with a 350 engine?
take the line off of it and see if it is pumping air
How much power will an 89 Chevy 350 pump out w cold air intake and long headers 3 inch exhaust?
Enough. Get it dyno'd.
Where is the windshield washer pump located in a 1994 ford e 350?
remove air inlet, then auxiliary battery, then battery tray. the pump is located under and attached to the reservoir
What are all the original emissions parts originally equipped on a 1975 Chevy Cheyenne 350 4x4?
EGR valve, purge valve, And maybe a air pump.
How do you remove power steer in pump on factory no air Chevy?
You have to remove the pulley first and you need a power steering pulley puller to do it. You can get one from Napa for usually about $40. There are bolts behind the pulley that hold the pump to the mounting bracket.
Do you need an Air Pump on a Chevy K10 pickup?
No you do not.
Chevy trailblazer 2004 air vents do not blow air?
If the air vents of the Chevy trailblazer 2004 are not blowing air, have the fuel pump checked.
How do you bleed the clutch on a 95 Chevy Camaro?
Remove reservoir cap and pump the clutch pedal until air bubbles rise and pedal feels firm.
What can be wrong if your Chevy 350 is running very hot after you replaced the water pump?
Air in the system. Bleed the system. Defective thermostat, clogged radiator, defective cooling fan or fan clutch.
Why is it difficult to remove an air sucker pressed to a surface?
it is hard to remove since the air outside the pump cannot enter or amalgamate witht the air that exists inside the pump.
