0
Can you remove an oil pan from a 1979 corvette without pulling the motor?
Wiki User
∙ 14y ago
i removed the oil pan in my 1980 to replace the pan seal and the only thing you need to do is drop the steering link by just unbolting it, you dont even have to remove it
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Can you replace a 1976 corvette oil pan without pulling the motor out?
Yes, the crossmember for suspension is in front of the engine. Very easy job.
How do you change blower motor on 2001 corvette?
Remove the wiring harness from the back of your 2001 Chevrolet Corvette blower motor. Remove the blower motor retaining bolts. Remove the blower motor fan. Reverse the process to install the new blower motor.
Can rod bearings be replaced without pulling motor 1994 Toyota 4WD 6 cyliner?
Yes, you do not have to remove the engine.
Can you change the oil pan gasket on a 1978 corvette without pulling the motor?
Yes, you have to remove the steering linkage under the oil pan and the flywheel cover. Also I think you have to turn the engine so you have maximum clearance from the crankshaft. You should then be able to remove all the oil pan bolts and work out pan.
1996 dodge ram sport 1500 how do i change the rear main seal without pulling the motor?
Remove the trasnsmission and you can then replace the seal.
Can a oilpan gasket be changed without pulling the motor on a 1998 ford ranger 2 wheel drive?
Yes! Remove whatever is necessary to allow you to remove the oil pan.
Can a oil pump be replaced on 1994 Ford Ranger 4.0 without pulling motor?
Can the oil pump be replaced on 1994 Ford Ranger 4.0 without pulling motor?
Can you drop the pan on a 1991 Ford Explorer without pulling the engine or axle?
take the motor mount bolts loss and lift the motor.you should be able to remove it
A diagram of a 1981 Corvette 350 motor?
diagram of motor od 1981 corvette
Can you change your freeze plugs without pulling the motor?
It is impossible to do it you have to pull the engine
Can an automatic transmission be removed from 95 GEO without pulling the 1.3L engine?
yes, remove the driver side tire, then unbolt the tranny from the morot and pull it out the bottom. (best way without taking the motor out.)
Where is the blower motor on a 2000 corvette and how to remove it?
Under passanger dash panal.There is plastic fasiner holding a kick panal up the blower motor is above it.
