Yes, the crossmember for suspension is in front of the engine. Very easy job.
i removed the oil pan in my 1980 to replace the pan seal and the only thing you need to do is drop the steering link by just unbolting it, you dont even have to remove it
Remove the trasnsmission and you can then replace the seal.
Can the oil pump be replaced on 1994 Ford Ranger 4.0 without pulling motor?
Replace the eledctric antenna or "pull the plug"
We have an article right here: http://www.corvettemagazine.com/component/content/article/39-body/139-corvette-wiper-motor-replacement.html
diagram of motor od 1981 corvette
It is impossible to do it you have to pull the engine
Your ignition switch has failed. There is a good chance that the wiring plug for the switch has melted slightly due to a blower motor that is pulling too many amps. You will have to replace the switch, plug, and blower motor.
NO THEY ARE NOT.
Put a jack under the engine for stability. Unbolt one motor mount, and jack the engine up slightly. The mount should be able to be removed, replace it and repeat for the other side.
I don't believe you can because the oil pan on vans are double sump pans and there wouldn't be anyway to get the pan out of the way because of the crossmember.
I have a 1988 corvette I need to change the headlight motor but cant get the motor free from the body This answer is a question.