0
The knock sensor is in the engine V under the intake manifolds and coolant crossover pipe. As it requires considerable disassembly and an expensive new gasket set to reach it, I suggest you make very sure there is something wrong with it first. You will have to remove the upper and lower intake manifolds and coolant crossover pipe assembly to reach it. Just because you are receiving a trouble code for it does not mean there is anything wrong with it. This sensor shares a circuit with other components that often will set a "ghost" trouble code.
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
How do you remove a knock sensor in an Oldsmobile cutlass ciera?
where is the knock sensor located on 93 cutlass ciera
How many knock sensors on a 1997 Cadillac eldorado and where are they located?
One Sensor.... Removal Procedure 1. Remove the intake manifold. 2. Disconnect the knock sensor electrical connector. 3. Remove the knock sensor. Installation Procedure 1. Install the knock sensor. Tighten the knock sensor to 19 Nm (14 lb ft). 2. Connect the knock sensor electrical connector. 3. Reinstall the intake manifold.
How can you remove knock censor on a Nissan pathfinder 1996?
how you can remove the knock sensor from a 1996 Nissan pathfinder i need a picture
Where is the knock sensor in a 2000 villager?
the knock sensor is under intake, must remove intake and it is under two coolant lines.
Where is the knock sensor on a 2005 silverado 5.3 v8?
There are 2 knock sensor under the intake manifold, You will need to remove the intake to get to them.
How do you replace the knock sensor on a 2001 Chevrolet Tahoe?
you have to remove the intake, and there are 2 knock sensors.
Where is the Knock Sensor in a s reg subaru impreza?
Remove the intercooler first. The knock sensor is located under its loation. But you will have to remove some breather pipes to get to it. You will need a long ratchet.
Where is the knock sensor on a 99 GMC sierra with a53 liter?
knock sensor location is under the intake manifold you have to remove intake their is two knock sensors front and rear
Where is the knock sensor located in the 1999 Mercury Villager?
the knock sensor is under intake, must remove intake and it is under two coolant lines.
How do you check a knock sensor?
remove the sensor, backprobe the plug with a multimeter set on voltage, tap the knock sensor lightly with a spanner, you should see voltage respond by increasing whenever you tap it, this means your knock sensor is working correctly. if it does not move however it means that the sensor is faulty.
Location of knock sensor for Pontiac G6?
The knock sensor for a Pontiac G6 is located on the side of the engine. It is mounted at the exhaust manifold.
Does a 94 integra have a knock sensor?
LS does not have a knock sensor. GSR does have a knock sensor
