answersLogoWhite

0


Best Answer
Copy

I have a 1994 caprice wagon with a 350 in it and I just removed the oil pan. It was a hard job to do.First of all the oil pan bolts were hard to get to. Then I had to remove the starter and the oil cooling lines and the oil filter housing with a Allen wrench (metric). then I had to remove the motor mount bolts and jack the engine up as far as it could go and I barely had enough clearance to get the oil pan off.So I guess if you had to do it it could be done... Hope this info helps you out.

User Avatar

Wiki User

โˆ™ 2011-09-12 14:07:34
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar

Add your answer:

Earn +5 pts
Q: Can you remove the oil pan on a 1994 Chevy Caprice Classic with the 5.7LV8 without pulling the motor?
Write your answer...
Submit

Related Questions

1996 caprice classic?

1996 caprice can you remove 4.3 engine and install a 5.7?


How do you remove the transmission on a 1989 Chevy Caprice Classic Brougham?

with tools


How do you remove heater core on a 93 Chevy Caprice classic?

How to change a heater cord for a 93 chevolete caprice


How do i change the fuel pump on a 1996 caprice classic?

Located in the fuel tank - may have to remove for access remove tank?


How do you change the rear brakes for a 92 caprice classic?

You will need to remove the tire and wheel from your 1992 Chevrolet Caprice Classic. Remove the brake shoe spring and caliper. The brake shoes will come off. Reverse the process to install the new brake shoes.


How do you remove the dash speakers in a 87 caprice classic?

Remove the whole front panel, and get a manual on how to re-do the whole dash interior.


How do you remove play from steering on 93 Chevrolet caprice classic?

Check the front end components for the cause


How do you put oil in a 1987 Chevy Caprice classic?

Remove oil-filler cap and add oil...


How do you replace Fuel pump on a 1992 caprice classic?

You will have to remove the gas tank to gain access to the fuel pump.


How do you change the fuel pump on a 1994 Chevrolet Caprice Classic?

You have to remove the fuel tank to access the fuel pump.


How do you remove front driver side door panel on 1993 Chevy caprice classic?

The 1993 Chevy Caprice Classic drivers side door panel is held in place with for retaining bolts and 10 retaining clips. Remove the retaining bolts and pry outward on each retaining clip.


How do you replace the fender on a 1982 caprice classic?

The 1982 Chevrolet Caprice fender is held in place with eight retaining bolts. Remove the retaining bolts and the fender will come off.


How do you replace heater core in a 1983 Chevy Caprice classic?

Drain the water from your 1983 Chevy Caprice Classic cooling system. Remove the heater core water supply hoses. Remove the heater core retaining bolts. Reverse the process to install the new heater core.


How do you replace the trunk lock on a 1993 caprice classic while it's closed?

It is not possible to replace the trunk lock on a 1993 Caprice Classic while the trunk is closed. A person will have to remove the back seat, crawl into the trunk and open the lock manually before it can be replaced.


How do you remove a carburetor from 1987 Chevy Caprice classic?

open the trunk lid and lift it out. Watch your head when reaching in. 87 had TBI.


How do you replace an electric antenna on a 89 caprice classic?

In my 89 you need to remove the wheel and the inside wheel housing, to get full access to the antenna.


Where is the fusebox on a Chevy Caprice classic?

AnswerLook under the kick panel driver's side. Should be to the above left of the brake pedal.For 1991 and up Caprice, open the driver's door and remove the cover from the side of the dashboard.


How do you get a transmission pan down from a 1991 Chevrolet Caprice Classic?

Remove the bolts but be prepared for alot of transmission fluid pouring out. You will need a large drain pan.


How do you remove starter in 1991 Chevrolet caprice classic?

Disconnect the battery, locate the starter.. remove the mounting bolts, bring the starter down to where you can reach all of the wires going to the solenoid, and disconnect those.


How do you change the ignition on a 1991 Chevy Caprice classic 350?

remove the lower shroud on the steering column, and then the 2 bolts that hold the column in place, it should be accessable then.


How do you remove the governor on 1991 Caprice Classic?

You do not as there isn't one. The computer has a built in REV Limiter which cuts back the fuel supply to the injectors when a predetermined speed is reached.


How do you tell if my starter is bad on my 1991 Chevy Caprice classic?

The only 100% sure way to know is to remove the starter and have it bench tested at an auto parts store.


How do you fix my turn signal switch on the steering wheel on a 83 Chevy caprice classic?

In most cases you will need to replace the turn signal switch on the steering wheel for your 1983 Chevy Caprice Classic rather than fixing it. To replace it, remove the horn pad and then use a steering wheel puller and compressor to remove the steering column. You will then remove the signal along with the wiring harness and bus fuses. Replace the signal and wiring and then replace the steering column itself.


Where are the fuse boxes located on a 1988 Chevy Caprice classic?

Under sterring colum right on fire wall. some are hard to remove use niddle nose pliers.


Can you change a rear main seal on a 1994 caprice without lifting the motor?

Sure... you'll just have to remove the transmission & flywheel.