answersLogoWhite

0


Best Answer

GM. did not put a 350 engine in there trucks in 2000

You either have a 6.0L, 5.3L or 4.8L and the oil pump is not in the oil pan.

It is built into the timing chain cover on the front of the engine. aftually the year 2000 was the last year that GM put a 350 engine in their 2500 and 3500 series trucks and the oil pump is in the oil pan attached with one bolt and two lineup pins. when you get the oil pump from the parts house you have to install the screen tube which comes seperatly, before installing the pump its self. with this being a 3500 series truck you can remove the oil pan with the engine still in place. it also gives you more room if you also remove the oil filter housing.

User Avatar

Wiki User

15y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Can you remove the oil pan on a 2000 Chevrolet one ton truck 350 engine to replace the oil pump with out pulling the engine the oil pressure is dropping when you come to a stop?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

No fuel pressure 2003 Chevrolet Malibu?

replace the fuel pump that is in the gas tank.


How do you change the transmission pressure control solenoid on 2003 Chevy impala?

how do you replace a transmission pressure control solenoid in a 2003 chevrolet impala


Why did the Chevrolet Sonic replace the Aveo?

It didn't replace it. The Chevrolet Aveo's name changed to Chevrolet Sonoc.


Can you remove the oil pan on a Chevrolet 350 engine to replace the oil pump with out pulling the engine?

Need to know the year and what you are working on. Ask your question again with this info.


Replace your starter 1998 Chevrolet Cavalier?

replace the starter on a 1998 Chevrolet cavalier


How do you replace a heater core in a 2001 Chevrolet Blazer?

how do i replace a heater core in a 2001 Chevrolet blazer


How do you replace the fuel pump on a 1999 Chevrolet Malibu?

Relieve the fuel pump pressure. Remove the fuel tank and on the top is the fuel pump module. Remove the module and replace with a new one.


Can you replace crankmainsand rod bearings without pulling off heads and removing pistons from bores?

No. Crank and main bearings can be get at by dropping the oil pan, but to get to the small end rod bearings you've got to get the pistons out.


How do you get the front axle out on the passenger side of a 1986 ranger 4x4 to replace the ujoint?

you have to start by pulling out the driver side then dropping the pod out of the center of the Dana 27 to take out the c clip then the axle should pull right out


How do you replace wiper crank arm for 2001 Chevrolet impala?

how do you replace wiper crank arm 2001 chevrolet impala?


How do you replace rear window on 1989 Chevrolet caprice?

The rear window on a 1989 Chevrolet Caprice is replaced by prying out the retaining seals and pulling the glass out using large suction cups. New seals are installed, a bead of silicone ran along the seal, and the replacement glass popped into place.


Where is fuel pressure valve on 2002 escort zx?

In a 2002 Escort ZX, the fuel pump has a check valve built into it. If the fuel pressure is dropping, then it is a bad pump. You would need to replace the entire pump. It could also be low compression.