Yes I can but it is easier if I have a helper to hold the tub shoe in place unless it is a standing waste then I do it alone
yes
The piece in the drain is screwed into the drain under the tub It is usually corroded and is not going to unscrew. You can use a sawsall or jig saw to cut the drain in 3 or 4 places around the opening and peel the piece out. You can also disconnect the drain under the tub and just leave it on the tub. There should be access to the back side of the tub. Usually a panel or door in the back of a closet that is in the room beside the bath. If there is no access, you will need to make one so that you can connect the drain to the new tub.
You step on the plug in the drain? The plug is part of the trim ring and screws into the drain. It seals the drain to the bottom of the tub. You can remove it and replace the drain completely, but you can't take out the plug.
You screw the drain piece out of the tub. Not easy,as there are many threads on it. You can get a special tool for it in plumbing stores.
Can someone please assist. I am have the same issue. Toronto CA
Once the old tub gets into the drain it is impossible to remove.........
Usually. Going through the overflow drain gets you straight into the drain without having to make the sharp bend in the tub drain. There could be a trap that comes apart in the drain underneath if it is accessible.
Connection of the washer drain hose to the tub drain is very important. This will help prevent leaks for example.
You remove the existing tub shoe and related fittings and install a new assembly. In some cases a reciprocating saw will be needed to cut the shoe flange located inside the tub
By standing in front of the tubs apron and looking at the tubs outlet and if it is on the right it is a RIGHT HANDED TUB
15-16 inches from back wall. 8-10 inches from side wall tub drain is on. Measurements are to center of tub drain hole. Measurements are close, not exact, and are for a standard tub.
It should be almost to the wall. When the tub is in place you'll be installing the drain and overflow. You'll then connect these to a p-trap and all of that will be connected to the roughed in drain. Give yourself a little room to work, and cut the concrete back to give yourself room to get in. You'll do the connecting from the end of the tub, so also make sure you have access. When it's all over, some city building and zoning departments are requiring that you pour concrete to seal off the exposed ground under the drain.