answersLogoWhite
Oxygen Sensors
Ford Tempo
Ford Explorer Eddie Bauer
1995-2005 Chevy Cavaliers

Can you replace an oxygen sensor on a 1992 ford tempo yourself and where is it located?

121314

Top Answer
User Avatar
Wiki User
2005-11-17 00:28:03
2005-11-17 00:28:03

Yes, you can do it yourself; the O2 sensor will be located on the exhaust manifold/pipe close to the engine; you usually have to get under the car to see it; they sort of look like a spark plug with a couple of wires attached. Many times a special deep socket is needed. It sometimes is a good idea to apply some WD 40 to the threads the night before as they can be corroded in place. I hope this helps you. Mark

1

Related Questions

User Avatar

The O2 sensor is located on the exhaust system there might be more then one

User Avatar

THE O2 SENSOR IS LOCATED ON THE MANIFOLD. IT JUST UNSCREWS OFF THE SIDE OF IT, THEN YOU JUST UNPLUG IT.

User Avatar

To replace the oxygen sensor on a Honda Odyssey, first unscrew the sensor. Then use a 22 mm socket or 7/8 inch wrench to replace the oxygen sensor.

User Avatar

unplug the connector, remove the oxygen sensor, it is located under the vehicle at the catalytic converter. install new oxygen sensor, plug in connector. done.

User Avatar

Oxygen sensor is located at the exhuast Manifold.

User Avatar

The 2002 VW oxygen sensor is quite simple to replace. Remove the wiring harness. The oxygen sensor will simply pull out.

User Avatar

The front oxygen sensor is located on the exhaust manifold of the BMW 318ti. The rear oxygen sensor is located in the head pipe.

User Avatar

To replace the oxygen sensor disconnect the oxygen sensor electrical connector. Use an oxygen sensor socket to remove the sensor. spray the sensor with penetration oil if it is difficult to loosen. install in reverse.

User Avatar

An Oxygen sensor does not reset. You have to replace them and yes they are expensive.

User Avatar

You bring it to a service station and tell them to replace the oxygen sensor.

User Avatar

how do you replace oxygen sensor of 2001 bmw 318 ci es

User Avatar

How do i replace speed sensor on 1992 toyota previa and where is the sensor located

User Avatar

The 1996 Buick LeSabre oxygen sensor is located on the air cleaner housing. Remove the vacuum hose. Pull the sensor out. Reverse the process to install the new sensor.

User Avatar

The upstream heated oxygen sensor is located ahead of the catalytic converter The downstream heated oxygen sensor is located behind the converter

User Avatar

The upstream heated oxygen sensor is located ahead of the catalytic converter The downstream heated oxygen sensor is located behind the converter

User Avatar

The upstream heated oxygen sensor is located ahead of the catalytic converter The downstream heated oxygen sensor is located behind the converter

User Avatar

The upstream heated oxygen sensor is located ahead of the catalytic converter The downstream heated oxygen sensor is located behind the converter

User Avatar

A 1969 car would not have an oxygen sensor.

User Avatar

The upstream heated oxygen sensor is located ahead of the catalytic converter The downstream heated oxygen sensor is located behind the converter

User Avatar

The oxygen sensor is located in the exhaust manifold near the firewall. It is easier to get to the sensor from under the vehicle.

User Avatar

In the exhaust pipe, ahead of the catalytic converter. You'll need a 7/8' box end wrench or an oxygen sensor socket to change it. To clear the codes, just disconnect and reconnect the battery.

User Avatar

The oxygen sensor is located on the exhaust manifold and is the only item on the exhaust with wires going to it.

User Avatar

where is the oxygen sensor in a 2004 astro van

User Avatar

01 toyota salara oxygen sensor how to replace it code p1135 p1155


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.