yes you can, just look in your manual for proper procedure and you are set.
To reset "CHANGE OIL" light, turn the ignition switch to the run position without starting the engine. Fully depress and release the accelerator pedal 3 times within 5 seconds.
In order to reset the oil change light on a 2006 Hyundai Tuscan you need to take the car to the dealership or your local oil changing station.
Just changing the oil doesn't do anything to the gauge, hold reset button down until readout changes change the oil
After changing the engine oil, the system must be reset. With the ignition key to ON (engine not running), push the RESET button located in the driver's side instrument panel fuse block. The CHANGE OIL light will start to flash, press and hold the RESET button again. The reset is complete when you hear the chimes and the CHANGE OIL light goes out.
oil servis reset without using a computer http://www.kofla.net/chevrolet.htm
Reset the change oil light on Mazda 3
Your owners manual should tell you how to reset the light.
how do you reset change the oil light in a 2004 alero?
Because you need to reset the light after you change the oil. Changing the oil doesn´t turn off the light automatically , you need to reset it. there is a very small push button on the dash board that has a label "RESET OIL CHANGE", with the engine off, push and keep pushing while you turn the key to power up the accesories but don´t turn the engine on. the light will go off after a second or so. Because you need to reset the light after you change the oil. Changing the oil doesn´t turn off the light automatically , you need to reset it. there is a very small push button on the dash board that has a label "RESET OIL CHANGE", with the engine off, push and keep pushing while you turn the key to power up the accesories but don´t turn the engine on. the light will go off after a second or so.
The transit brake warning light, on a Ford, can be reset by changing the brake pads. If the warning light is still on after changing the brake pads remove the fuse for 10 seconds.
The transit brake warning light, on a Ford, can be reset by changing the brake pads. If the warning light is still on after changing the brake pads remove the fuse for 10 seconds.
With the engine off, press and hold the mileage reset button on the instrument panel. Turn the key to "on" not start while still holding the button(10 to 30 secs.)It should reset the light. Don't reset this light without actually changing your oil though, that could be bad.