1200W on 10g cable would not be reccomended.. You will most likely have problems with the amp not getting enough power and shutting itself down.. At 1200W you would most likely be looking at 4g or bigger.
You can, but the Sub will not put out its full sound power.
good sound tbh nice movement
Yes, the larger cable can carry more load (current) than the other cable.
power cable goes from battery to cap + terminal. separate power cable from cap + terminal to the amp. make sure the amp and cap are grounded.
Yes, the larger cable can carry more load (current) than the other cable.
First you will absolutely need an amp to power any subwoofers. Nowadays subwoofers come along with amp..& normally one 1200watt subwoofer decrease your car battery lifetime to 2-4 month
the remote wire only needs a power source for the amp to turn on, so if u have a looped cable running from the remote input on the amp to the front of the car with a switch and then back to the power cable on the amp u can control when the amp is on just by turning the switch on or off. otherwise u will have to figure out which cable on the back of the stereo is switched power, or which cable only supplies power when the car is running. and that would require a wiring diagram.
This unit requires a PWM power supply.
No. The amperage describes the total electrical energyeither produced or consumed. Voltage just describes the potential. If the power cable or power supply are only capable of 1 amp and the device consumes 2 amps... sorry, you don't have enough electrical energy available.
This unit will require the PWM power supply system
200 amp/25ft long cable
7.2kW shower = 32 Amp fuse = 6 mm2 cable size7.5kW shower = 40 Amp fuse = 10 mm2 cable size8.5kW shower = 40 Amp fuse = 10 mm2 cable size9.5kW shower = 40/45 Amp fuse = 10 mm2 cable size10.5kW shower = 45 Amp fuse = 16mm2 cable size