Want this question answered?
It uses an orifice in the top rear of the vavle cover not a PCV vavle.
on the valve cover as your faceing the car you will see a hose on the left side of the vavle cover. This hose goes to the intake plentum. the hose on the valve cover end goes to a connection that has a 19 mm nut screwed into the valve cover.loosen this nut remove the plastic cover and look in vavle cover. you will see the pcv vavle take a pair of needle nose and pull old pcv vavle out and replace.
17 ft./lbs.
yes in the vavle cover.
its located on top of the valve cover. its located on top of the valve cover.
Crankcase breather tube.
its usually in the drivers side vavle cover. look for a 3/8 rubber hose going to the valve cover. the pcv vavle goes into a rubber grommet and usually comes out at 90 degree angle.
pull the pcv valve out of the vavle cover grommet, pull the hose off of it, put a new one in, put the hose back on, yay!!
its on the rear of vavle cover,top and in the middle of it
on the valve cover (long metal cover on either side of intake. normally on drivers side vavle cover where it says OIL
Cracks Rips Improper Seal
If you see oil in the spark plug chambers in your Accord you will need to replace the vavle cover gasket. Oil from the top end of your engine (camshafts) is leaking through the vavle cover gaskets into one or more of the spark plug wells. Easy fix!!!!