answersLogoWhite

0


Best Answer

Yes I actually did it yesterday on my Land Rover I could not get my tail light to come on only my brake light. Use a decent wire like one side of a good speaker wire will do it's what I used. Tie it into the "hot" or positive wire of a working light into the positive of the non working. Make sure the lights you are tieing together do the same job i.e. Q brake light to a brake light. If that doesn't work check your ground. Also this only helps if the wiring is bad that is sending the light the signal if the fixture is bad you will have to replace it.

User Avatar

Wiki User

12y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Can you tap a wire into the left brake light wire and run the new wire under the car and tap into the right brake light wire to make the right brake light work?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

When you switch on the light brake light does not come on but if you switch it off hit the brakes it comes on?

with the park lights on both left and right side are lite. but when the brake is applied the right brake lights up and the left goes out(doesn't light up)


What fuse is the brake lights on 2000 ford expedition?

The left brake light works the right brake light doesn't and the bulbs is good


Where is the brake light switch located on a 1994 TC?

It is mounted to the left of the brake pedal under the dash.


1990 cutlass left brake light fails to come on does slightly blink in sync with right brake light when rear park running lights are on in order to see the left brake light blink slightly?

its a ground wire


Would the brake switch be two buttons that are released when the brake is pushed on a 1994 GMC jimmy?

Yes. One switch is for the left and right brake light assemblies; and, the other is for the 'third' brake light.


Adjust brake light switch?

you have to take off the panel that is covering around the brake and then you will see the brake light switch on the front side of the brake you can just simply turn it left or right and that will adjust it


Right side brake light goes out but left side works?

Check the bulb.


Where is fuse for the back brake lights located on a peugot 307?

The fuse for the left brake light is # 5 and the right and 3rd brake light fuse is # 17 in the fascia fuse box


What number is the brake light fuse on a 2000 Lincoln LS?

Number 7 fuse on the right brake light in the trunk fuse box number 5 for the left side brake light also in the trunk.


What is a third brake light used for?

A third brake light is used to provide a deceleration warning to vehicles that can't see the left and right lights. You can learn more about these brake lights at the Wikipedia.


Where is the brake light fuse located in a 1992 Jeep Wrangler?

the brake light fuse is located on the firewall under the dash beside the park brake second or third up on the left hand side


How do you wire a brake and turn signal light up to your car its an aftermarket one but it only has 4 wires black red yellow blue?

i have conected the black and red wire to the brake and it works (the brake light that is) and i conected the blue and white to the signal lights each wire being left and right signal and it all works. but when i brake all of the light lights up the red bar for the brake and the orage bars left and right when i signal left or right whiles braking the signal works but the other signal light sticks on with the brake light. so if any one as any idears please let me know thanks