My guess would be yes. You won't know for sure until you remove them both. If they wiring is the same, then it will work.
How to drill out ignition switch on 1985 ford f150?
Posible relay problem
The actual problem is the starter continues to turn after key is turned off and pulled out of ignition.
We are replacing the ignition switch on a 1976 ford F150 Need some help - give us directions
no. Make sure wiper is in "OFF" position before you turn off your car.
Ignition relay is probably shot. It is in the power distribution block in the motor comprtment.
The ignition switch is usually mounted to the steering column and is operated by a linkage rod. NOTEOn column-mounted ignition switches, don't confuse the switch with the lock cylinder and keys. The ignition switch is not normally visible. On some vehicles, the steering column support has to be removed and the column lowered to find the ignition switch. On others, the switch is accessible under the dash.The ignition switch is operated by the key switch. Courtesy of Ford Motor Company. To replace the switch: * Remove the ignition switch wiring harness. * Unbolt it from its position. * Bolt the new switch into position. * Attach the witing harness.
The ignition switch is usually mounted to the steering column and is operated by a linkage rod. NOTE On column-mounted ignition switches, don't confuse the switch with the lock cylinder and keys. The ignition switch is not normally visible. On some vehicles, the steering column support has to be removed and the column lowered to find the ignition switch. On others, the switch is accessible under the dash.The ignition switch is operated by the key switch. Courtesy of Ford Motor Company. To replace the switch: * Remove the ignition switch wiring harness. * Unbolt it from its position. * Bolt the new switch into position. * Attach the witing harness.
pull the distubartor and have the module checked its more then likely bad i had the same problem in my 90 f150 with the 300 straight 6 i changed it and it fired right up
I just purchase a f150 that needs a new ignition switch and the man at auto zone gave me directions with pictures and diagrams, I hope this is of some use. Good Luck!
TAKE A ALLEN KEY SMALL ONE AND RIGHT UNDER THE SWITCH IS A HOLE PUT IT IN THERE AND TURN THE KEY TO START POSITION AND PUSH THE PIN WIGGEL THE IGNITION SWITCH AROND IT WILL COME OUT
To hookup the solenoid switch on F150 pick-up 5.0 after replacing it, first connect a voltmeter or test light to the solenoid's S terminal. Make sure the starter receives voltage at that terminal when the ignition switch is in the on position.