Want this question answered?
You must use thermocouple wire (of the same type as the thermocouple) to extend the circuit. If you switch to a different wire the point of connection between the two becomes a thermocouple junction itself, and the resulting voltage from that junction will skew your reading. You can use any wire to extend a thermocouple connection if you know the temperature of the junction where the thermocouple wire ends--this becomes the reference junction.
for temperature sensing i will suggest a RTD or A THermocouple. for temperature sensing i will suggest a RTD or A THermocouple.
You use a thermocouple as the input to the amplifier circuit.
The output of the thermocouple is linear.
thermopile
No, as the voltage of a single thermocouple is very low , you need a thermopile (thermocouples connected together) and a circuit to get a readable voltage at the other end.
A thermopile generates electricity from the heat of a pilot light. It generates about 750 mV that turns on the main gas valve to the fireplace.A thermocouple is heated by the pilot light but it uses pressure to hold the pilot light gas supply valve open. When the thermocouple is heated, pressure increases holding open the main gas valve. If it cools down, the pressure goes down and closes the gas valve.
to detect radiation
You should not paint a thermocouple.
To create a thermocouple one needs thermocouple wire, a means of spot welding the wire, and wire strippers. A thermocouple is used to measure temperature.
You must use thermocouple wire (of the same type as the thermocouple) to extend the circuit. If you switch to a different wire the point of connection between the two becomes a thermocouple junction itself, and the resulting voltage from that junction will skew your reading. You can use any wire to extend a thermocouple connection if you know the temperature of the junction where the thermocouple wire ends--this becomes the reference junction.
measuring temperature difference
You could use a thermocouple.
I am assuming that you mean switching a millivolt gas value. The switch applies a voltage to the gas valve thus allowing gas to flow. The voltage is provided by a thermopile. This device transforms the heat from the pilot into a voltage that can be used to control the valve. This system does not require an external voltage source. It does require the pilot to continuously operate. A thermopile consists of a number of thermocouples that are wired in series. This allows an increase in the voltage that would be provided by a single thermocouple.
for temperature sensing i will suggest a RTD or A THermocouple. for temperature sensing i will suggest a RTD or A THermocouple.
you use a thermocouple instrument
Most thermocouples are held in place at the pilot light by pushing them into a clip that grabs it on both sides. The control end is held in place by a nut that the shaft of the thermocouple goes through.