This would depend upon your TV and the receiver and if it has a coax port available on the back. You can use an RG6 coax cable between the receiver and TV. Most newer HD receivers do not have a coax port on the back
For Dish Network, we use RG6 coax cable to allow a higher frequency range for the satellite signal from the dish to your receiver. Any coax cable not rated at RG6 could affect the signal.
The type coax you need depends on the type service you have. For satellite service, we use a higher rated coax cable (RG6) to allow for a higher frequency for channels and back feeding capability. RG59 is a lower rated cable.
We use a RG6 coax cable from the dish to the receiver. The cable used between the receiver to the TV varies.
I am not certain on T-90 my tv installer said to use rg 59 i am not certain why.
Cable modems use RG-6 coax cables.
Depends which connections you would like to do. In most cases you are unable to use multiple component or HDMI connections at the same time. In this case, your only option would be to use a satellite splitter & satellite cable that looks similar to coax (cable that the cable providers use).
Typical coax cable uses a different standard than RCA. You will need to use a converter box.
It could be star or bus, but historically, coax cable was used in bus architecture.
no.
No. The cable provider has to authorize the other modem on the network before it can be used, and they will not do that, since they want you to pay for another cable installation.
It depends on what you are trying to connect. If you were more specific, then answer could be more specific.
You can use RCA cables or coax. You will see on the back of your Dish receiver a TV out for either coax or the RCA cables out, then plug the cable into the input of your TV. Be sure to tune your TV to whatever input you choose to view dish satellite programming.