Yes. Coaxial cable is the preferred method for carrying the signal. The important factor is the frequency of the signal that is being carried by the cable. Most coaxial cable that you will want for carrying your signal will be RG-6. This will handle signals for radio, television, and satellite receivers.
It is not important whether it is an analog or digital program. Some manufacturers use a deceptive advertising technique and will emphasize that their cable is for digital signals. They want you to think that another competing product that does not make a claim to be for a digital signal is not suited for digital. The cable doesn't know the difference between a digital or an analog radio frequency signal. It handles both of them in exactly the same manner.
Some important specifications to consider when selecting a coaxial cable are:
-Bandwidth (what frequencies can it carry)
-Attenuation (how well does it carry the signal without weakening it)
-Impedance (proper impedance matching helps to carry the signal - most cable will be 75 ohm and will need to be used for 75 ohm equipment, 50 ohm cable for 50 ohm equipment)
Don't use a long cable when a short one will do. A longer cable attenuates (weakens) the signal more.
RG-59 can be used for short distances, but RG-6 is a much better choice.
RG-59 is not a good choice for HDTV or satellite signals, but it can be used for connecting a VCR to a television.
Cable modems use RG-6 coax cables.
This would depend upon your TV and the receiver and if it has a coax port available on the back. You can use an RG6 coax cable between the receiver and TV. Most newer HD receivers do not have a coax port on the back
For Dish Network, we use RG6 coax cable to allow a higher frequency range for the satellite signal from the dish to your receiver. Any coax cable not rated at RG6 could affect the signal.
Yes for digital audio if your Sony has a Digital Coax connection.
Typical coax cable uses a different standard than RCA. You will need to use a converter box.
The type coax you need depends on the type service you have. For satellite service, we use a higher rated coax cable (RG6) to allow for a higher frequency for channels and back feeding capability. RG59 is a lower rated cable.
To extend a coax cable without special tools you will need a second coax cable. You can plug the second coax cable into the end of the first one (the end that is plugged into the wall).
It could be star or bus, but historically, coax cable was used in bus architecture.
No. The cable provider has to authorize the other modem on the network before it can be used, and they will not do that, since they want you to pay for another cable installation.
if you are paying for phone only then most cable companies put a data trap at the pole or ped where your coax cable is connected. so no usable tv signals are there.
It depends on what you are trying to connect. If you were more specific, then answer could be more specific.
Iam pretty sure that baseband coax was 50 ohm and was used for networking computer, were broadband coax is 75 ohm and used in the cable tv industry.