0
What else can I help you with?
What size wire for electric cook top?
AWG # 6 copper or AWG # 4 aluminum
How do you connect the 3 pin plug?
One pin for phase other pin for neutral and third one is for earth/ground wire. In India the right pin is for phase, left pin is for neutral and pin on top side is for ground wire. This third top side pin is slightly bigger and longer compared to phase and neutral pins.
What is wrong with your single phase electricity meter if it does not show any numbers in the meter reading panel?
One of the conditions that would cause this is that there is no supply voltage to the top of the meter. Another problem could be, the neutral tickler wire has become disconnected.
Where is the knock sensor 1982 Corvette?
Down in front of starter screwd into engine block right hand side , big round brass with a single wire going to it. Has a single small stud sticking out on top of it for wire clip.
Can a 40 amp cook top be connected to 10 3 wire in a 30 amp circuit?
If you are talking about splicing a 40 amp cook top into an existing 3C #10 30 amp circuit then the answer is no. An appliance with that load ampacity needs to have its own dedicated circuit. This would consist of 3C #8 wire cable fed from a two pole 40 amp breaker located in the distribution panel.
How do you wire from an on-off 3 phase switch to a 3 phase motor?
To wire a three phase compressor, you will need a motor starter( three pole contactor) with a motor overload device sized for the motor run current. A single or double pole pressure switch. This example is for 208 volts, coil on starter should be rated for 208 volts. Bring the three phase conductors to the top of the starter from the disconnect and land them in the wire terminals. Bring the three motor leads to the bottom of the starter and land them in the wire terminals. Go back to the top of the starter, land a wire in A phase terminal ( left Hand phase) with the wire that is already there(some starters have provisions for two wires) take this wire to the pressure switch and land on one side of the contact. Land another wire on the other side of the contact and go back to the starter and go the "coil" terminal on the starter. Go back to the top of the starter B phase terminal(center phase) land another wire there and go to the starter overload device terminal. When the pressure switch closes you should have 208 volts present on the starter coil and it should pull in. Once the pressure switch is satisfied the contacts will open and the starter will drop out.
What wire on a 3 line wooden pylon is live neutral and earth?
On a 3-line wooden pylon, typically the top wire is the live wire, the middle wire is the neutral wire, and the bottom wire is the earth wire. It is important to contact a professional electrician to properly identify and work with these wires to ensure safety.
What wire goes to the top pin on a three pin wire?
hot wire
What are the main duties of a grill cook?
To cook things on the grill top.
Escort van starts then cuts out then will not start?
check the fuel solenoid is working usually by wriggling the single wire on the top will show if it cuts out if so replace
What is the location of the knock sensor on a 1997 legacy 2.5 gt?
On top of engine block,under throttle body(just a little to left if you were sitting in car), sensor has a single wire,a single twelve mm mounting bolt and white plug. Clean threads with wire brush during replacement.
Can I use the Uline brand degreaser on my cook top stove?
Yes you can use Uline brand degreaser on a cook top stove.
