0
Can you wire a 2 channel amp to a dvc sub using one channel per coil?
Wiki User
∙ 12y ago
if the sub can handle it yes....say if u have a 2000 watt amp 2 channel and u have a 2000 watt DVC sub then it will work but wouldn't advise doing that for great sound qulity
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
How do you wire a dual voice coil to an amp?
If you want to run both coils,you have to wire the positive to positive and negative to negative on your sub,then run a wire from each plug to the amp. Positive to the positive side of the amp and negative to negative side of the amp,(you can run in bridge mode or stereo if your amp can handle the load)
Bridge two subs to a four channel amp?
If you amp is bridgeable you run + sub wire to ch 1 + then the -sub wire to the - of ch 2 of the amp. The same with the other sub + ch3 - ch4 that's how to bridge your amp.
What color wire is the remote wire when using an amp with a factory radio in a 2000 Monte Carlo?
Yellow Wire.
How would you hook up 2 8 ohm woofers with a 4 ohm dual voice coil woofer?
You could with a 4 channel amp. Bridge it to two channels and hook up the two 8 ohm woofers in parallel on the one bridged channel. Then hook the two coils on the dual coil woofer in series with the other bridged channel on the amp.
How do you install two amplifiers into a subwoffer?
its better to get one amp for you sub then 2 because your going to have to spend more money with wiring and stuff. But if you really wanna do it you have to wire one voice coil to the other one and same for the other amp but if you have one voice coil you have to split the wiring into 2 neg and 2 pos then wire upto amp. HIGHLY NOT RECOMMENDED
What does a inductive ammeter do?
It measures current by creating a coil around the current carrying wire. Current flowing in the wire induces a current in the amp-meter proportional to the current flowing in the wire.
How many channels do you need to power my subwoofer?
mono or two channel are the best for subs but it depends on if your sub is dual voice coil or single voice coil, what ohm load the amp can handle, and if it is single voice coil and are using one sub you need to make sure you can bridge a 2-channel amp if that's the kind you chose... Next question you ask it may help to add a bit more detail. If I knew the sub brand and model, ohms, and if it's dual or single voice coil i could help answer that much better.
What color wire is the remote wire when using an amp with a factory radio in a 2002 ford escort?
black
How do you connect two amps to four subs?
Run a 2 sub per amp set-up. Get a distribution block for you power wire to split the power wire. You can run the remote wire from your stereo to one amp and then from the amp to the other amp. you will also need 2 sets of RCA's Easy way is too get a 4 channel amp to power 4 subs.
Can you mix an 8-3 wire with a 30 amp double breaker?
You never, ever mix wire sizes within a circuit. However you can wire a 30 amp circuit using AWG # 8/3 wire, although that is overkill and AWG #10 wire is what you would normally use on a 30 amp circuit.
What can you operate on 120 volts at 30 amps?
Yes, if you are using AWG # 10 wire. If you are using AWG # 12 then the answer is no you must use a 20 amp breaker. On AWG #14 wire you must use a 15 amp breaker.
How do you measure amps from a 3 phase motor?
thong each wire using amp meter
