I just changed the ashtray light in my 2000 Windstar LX. It is probably similar. Open the ashtray. Take a regular screwdriver and insert it between the top of the ashtray and the dash board in the center of the ashtray. There is a latch hidden there. Lift the screwdriver handle, which will press down on the latch. Then simply pull out the ashtray. It will be connected by the wires for the light. You can either disconnect the wires or carefully turn over the ashtray. When you turn it over you will see the light assembly attached to the wires. It snaps out of the ashtray. Then you can remove the light from the assembly by releasing the latches of both sides of the assembly. Then the light pulls straight out. Putting it back together is a little tricky. Once you have the new light installed and the light assembly put back together you need to reinstall the light assembly. This is a bit of trouble. Perhaps putting a piece of scotch tape around the assembly will help to get it aligned. It snaps back into place. Reconnect the wires if necessary and reinsert the ashtray.
we can change it through decreasing its value.
If the cupholder on the 2002 Windstar is the same as the 2001 then there is a small plastic clip on the top of the cupholder that locks in a groove when the cupholder is in the out position. Push the clip down with a small screwdriver and pull the cupholder out. (This works on a 1998 Windstar, also.) If you don't have to remove the housing for the cupholder et al, You can remove just the sliding part by reaching under it when its open and there is a small tang that you have to push down (towards the floor) and it will slide out Remove the center console (4 plastic screws. remove the center instrument panel trim (snaps off, but be careful not to break it.) remove 2 ashtray mounting bolts on the front (behind the trim you removed) open the ashtray to expose 2 mounting bolts under the ashtray, remove the light tray light (from underneath, it snaps off, and pull the ashtray ouy the front. (Sounds a lot harder than it is.
On a 2001 Ford Windstar : The warning light in the low right corner of your gauge cluster is the ( low washer fluid warning light ) * according to a drawing in the owners manual *
Not sure *which* light cover is being asked about, but the "Related Questions" below will cover all 3: headlight, taillight & running light in the front bumper cover
There are four bolts holding the ashtray, two in front, two in back.
You need to take out front dash from top to bottom via cdplayer, clock, over the a/c climate control. Once it's removed unplug the clock and it can be moved out farther to where you see the ashtray. Unplug the ashtray connector and the bulb should come right out, replace it and plug it back in, your done.
The 2001 Windstar is rated at 200hp
you don't because it does not have a light in it, or you can use magic. I'm confused, the Owner's Manual states Replacement Bulb Ash Tray Bulb No. 161. I checked parts replacement and found: Wagner Lighting - Ash Tray Light Bulb Fits Your 2001 Dodge Durango
On a 2001 Ford Windstar : That warning light means that one of your exterior bulbs has burned out ( the warning light between the door ajar warning light and the low engine coolant warning light , located in the lower right area of your gauge cluster )
A 2001 Intrepid does not have an oil change light.
The 2001 Windstar has no radiator cap. It has an antifreeze bottle.
Yes. The mirror on the 2001 Ford Windstar is the same mirror found on the 1999 Ford Windstar. They are interchangeable.