Rear: Brake, Back-up, Tail, Turn signal (3 bulbs, all # 3157)
To access the rear bulbs, open the liftgate and remove the two Phillips head screws from the side of the housing as shown in the center photo above. Slowly and firmly rotate the assembly away from the vehicle until it disengages from the ball pin socket that secures it in back.
Each of the three light sockets, all containing the same exact bulb type, can be removed by turning them counter-clockwise 1/4 turn.
(Note: Replacement sockets are available separately, Jeep P/N 4676589)
Pop the back door oopen and remove the screws from the location of the third brake light. When you do the console that holds the lights will pop down you might to use some force, once you got it off you can pull it down to see behind it and then you can remove the required light is out by turning the light socket left and the light bulb will be out and then you just take the light out and replace it and put everything back together. Pop the back door oopen and remove the screws from the location of the third brake light. When you do the console that holds the lights will pop down you might to use some force, once you got it off you can pull it down to see behind it and then you can remove the required light is out by turning the light socket left and the light bulb will be out and then you just take the light out and replace it and put everything back together.
Check out this website..this is how i fixed mine http://www.2carpros.com/forum/2001-jeep-grand-cherokee-laredo---brake-lights-not-working-vt4814.html
How to change the brake switch on a 2004 Jeep grand Cherokee Laredo
Sounds like your parking brake is on... this can also be an indicator that your brake fluid is very low
To reset the oil change required light: turn key on, engine off; press gas pedal to the floor three times; cycle key.
If equipped, it is above the liftgate glass.
tail light bulbs has two filaments inside. One for regular lights and a second for brake lights. One filament is burnt out. Change the bulb.
How to change the brake switch on a 2004 Jeep grand Cherokee Laredo
They aren't. The brake light circuit is not connected with the headlight circuit.
The 1993 Jeep grand Cherokee brake light switch simply plugs in and out. The brake light switch is located beneath the dashboard on the drivers side of the engine compartment.
Check the bulbs in case they have fused, next check the fuse, and finally it could be the brake light switch which may need replacing
what do you have to do to change the center brake light
How do you install passenger tail light kit for a 2004 grand cherokee?
change the brake lights check the fuse check the brake light swtch
WHICH brake light?
Check the sensor on the brake pedal arm.
how to change a brake light on 2002 Nissan altima
Change brake light bulbs Just remove the rear license plate. You can change the backup lights and brake light easily.
The Chevrolet Colorado brake light switch is quite simple to change. The brake light switch simply plugs in and out.