Change brake light on Jeep grand Laredo?

Answer 1

Rear: Brake, Back-up, Tail, Turn signal (3 bulbs, all # 3157)

To access the rear bulbs, open the liftgate and remove the two Phillips head screws from the side of the housing as shown in the center photo above. Slowly and firmly rotate the assembly away from the vehicle until it disengages from the ball pin socket that secures it in back.

Each of the three light sockets, all containing the same exact bulb type, can be removed by turning them counter-clockwise 1/4 turn.

(Note: Replacement sockets are available separately, Jeep P/N 4676589)

Answer 2

Pop the back door oopen and remove the screws from the location of the third brake light. When you do the console that holds the lights will pop down you might to use some force, once you got it off you can pull it down to see behind it and then you can remove the required light is out by turning the light socket left and the light bulb will be out and then you just take the light out and replace it and put everything back together. Pop the back door oopen and remove the screws from the location of the third brake light. When you do the console that holds the lights will pop down you might to use some force, once you got it off you can pull it down to see behind it and then you can remove the required light is out by turning the light socket left and the light bulb will be out and then you just take the light out and replace it and put everything back together.

Answer 3

Check out this website..this is how i fixed mine http://www.2carpros.com/forum/2001-jeep-grand-cherokee-laredo---brake-lights-not-working-vt4814.html