0
You need to drain the system, the drain valve is located on lower driver side of the radiator. When the system is dry, shut the valve and fill the radiator with new coolant. Fill until the coolant runs out the top, fill the overflow tank to cold mark.
Start the engine and let it warm up until the thermosat opens. Standing in front of the vehicle there is a small bleed valve located on the right just above the thermostat open it until the coolant comes out and shut it back off. Located on the left of the engine just above the water pump is another bleed valve, do the same with it. You may have to do this two or three times before you have all the air out of the system.
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
How do you bleed air out of coolant system 97 Saturn?
procedure on how to bleed air out of coolant system on 97 saturn ls
How do you bleed your V6 coolant system?
how do i bleed my accord v6 2000 coolant system, its has air and the rev's gone up & down......
Where is the place you bleed coolant system?
It is not necessary to bleed the coolant system. If you mean "drain" the system, there is usually a plastic plug on the radiator or, you can pull the lower radiator hose off.
How Do you Bleed The Coolant System On A 1998 Beetle?
To bleed the coolant system on a 1998 VW Beetle, remove the top from the overflow tank. Run the car for 10 to 15 minutes to force any air out of the system, then check the coolant level. Add coolant as needed.
How do you bleed the coolant system on a 2002 impala?
There is a bleed screw on the thermostat housing. Remove the screw with the engine loose. Ounc you have pure coolant and no air you can close off the bleed screw.
How do you Bleed the coolant system on a 2002 Chevrolet Impala?
There is a bleed screw on the thermostat housing. Remove the screw with the engine loose. Ounc you have pure coolant and no air you can close off the bleed screw.
How do you bleed the coolant system on a 1999 mercury villager?
Not necessary on this vehicle.
How do you bleed coolant system after replacing thermostat?
what is the year make & modle of it??
How Do you Bleed The Coolant System On A 1998 2.0 Beetle?
Start by taking the top off of the coolant overflow reservoir. To bleed the system, run the 1998 VW 2.0 Beetle about 10 minutes, then check the coolant level. Add coolant if needed, then replace the reservoir top.
How do you bleed my coolant system?
As you did not include engine or Year info I will give a general answer. Look on the top of the engine, most GM products with a bleed system have a small brass pipe thread plug in the top of a black or aluminum casting. This is the bleed point, loosen the plug or valve and add coolant to the system until it flows from the bleed, tighten up the bleed. Done. Repeat if needed.
How do you bleed a Daewoo matiz after coolant change?
You don't need to it bleads itself
How to bleed air from coolant system in a 3.5 Olds Aurora?
Good luck haha..
