Place a pan under the drain valve on the radiator (back side of the radiator, right side) Reach up and open the valve letting the coolant out. (It is meant to be turned by hand, but you might need a pliers) After the coolant has started draining open the radiator cap to allow air into the radiator. Go back to the engine and open the thermostat cap (Large cap that looks like a radiator cap, has a two step turn - push and turn again removal). Remove the thermostat located under the cap by grabbing it, turning it to break the seal and pulling it up.
To fill - close the drain valve on the radiator. Leave the radiator cap off and start filling by pouring the coolant into the (still open) thermostat cap. Note - the thermostat needs to be still removed. Have an assistant watch at the radiator and when it gets full he needs to quickly put the radiator cap back on. Then continue to fill at the thermostat cap till the engine is full. Now start the car and let the coolant circulate, refilling at the thermostat cap when the coolant has dropped. After the car has warmed up, and all of the coolant bubbles have come out, fill the coolant to the top of the thermostat cap housing, replace the thermostat and cap and fill the reserve tank to the warm mark.
where is the coolant temperature sensor locate
what is the fuel pressure on a 1987 fiero gt
what about them?
1 per car
4 quarts with filter.
I have a 1987 Pontiac Fiero GT and the shift pattern is: 1 3 5 2 4 R
inside the gas tank
Right next to the oil cap
Inside the alternator
Fiero.nl then go to the mall section
They didn't make them with t-tops.
on a sticker located on the underside of the hood on the right side