answersLogoWhite

0


Best Answer

It sounds like a wheel bearing in your hub is worn out.These are hard to diagnose when you turn the wheel(or hub) by hand,they may seem fine but vibrate at higher speeds.Check if there is any dirt stuck in your rims or if a rim has lost a balance weight.

User Avatar

Wiki User

15y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Constant noise and vibration from front end CV axles changed It is a 1990 Ford Probe 2.2L 5 speed Can hear and feel through shifter and steering wheel?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What is a paddle shifter?

A paddle shifter is either of a pair of paddles fitted to the steering wheel of a high-performance motor car, allowing the gears to be changed up and down in a single movement, without using the clutch.


Where would you get an exploded diagram of a steering column shifter for a 1969 ford fairlane?

A person can get an exploded diagram of the steering column shifter for this car in its maintenance manual. It can also be found in the repair manual.


The steering wheel ignition and shifter are locked up how can they be unlocked?

my steering wheel is locked my tires are straight and everything and it refuses to unlock what do i do?


Where is the brake shift interlock solenoid located on 2003 Honda odyssey?

It is located on top of the steering column. Right above the shifter. There is also a lever underneath th steering column cover. Remove the cover and push the lever down, it releases the shifter.


Ford e 150 loose shifter wont go in park?

The shifter linkage bushings inside the steering column need to be replaced. They are available at your local Ford dealer.


How do you turned off OD-off in car?

there is a button on the gearshift or on 1 of the shifter rods on steering column


How do you remove the gear shift lever from a 1971 dodge pickup?

Assuming that it is anautomatic And it's just the shifter that you want, at the bottom of the shifter by the steering column there is a pin. Take a punch and drive the pin out.


How do you replace the steering column shift tube on a 1991 Ford LTD Crown Victoria?

how to replace shifter tube


Where is the neutral safety switch on a 1978 trans am?

Under the dash on the steering column or bolted to the side of the floor shifter


Where is the neutral safety switch on a 1971 cutlass?

underneath the steering column. it will have leads running from it to the firewall as well as to the shifter


Why won't my 1999 Oldsmobile Alero shift out of park?

If you can run the shifter down through the positions it may have broken loose at the transmission . If the shifter doesn't move at all it may be a problem in the steering column < unless it is a floor shifter >. If it is a floor shift model I'd start by checking the shifter release button to see if it is broken.


How do you remove a key that is locked in the ignition on a 1999 GMC Jimmy?

There is a broken wire below your shifter in the console. This controls a solenoid that releases the key. The shifter in the center consle has a part that controls a current to solenoid in your steering column. A quick fix is a nail or piece of wire to release the key. This is in the steering column. There is a pop out that must pushed in to release the key. A longer term fix to replace the part in the shifter.