The average cost to replace a 1995 Mitsubishi crankshaft is approximately $2000. The cost is dependent upon the mechanic shop's hourly rate.
Where is the crank position sensor 0n a 2001 mitsubishi Galant
pcm or crank sencer
Behind harmonic balancer and timing belt on the 2.4 3.6-4 hrs
Crank angle sensor reads rpm and sends the signal to the ECU (computer) to aid in the calculation of engine rpm, ignition timing, fuel injection and crankshaft position.
If it is a 4.3L engine it is located behind the harmonic balancer, passenger side.
Check with a "good" mechanic. They will hav a aual that outlines the average "shop" time to make this repair. They will give this info to you no chage.
how to ins toll a crank sensor on a 95 Mitsubishi 6v, but first of all my car crank to the point that it wanted to start but it does not start what might be the problem.
not behind the bell housing ?
there is no crank sensor on a Mitsubishi 3000 gt but there is a crank angle sensor that looks just like a distributor its in the back of the engine on top between valve covers
Replacing a CPS can be easy or hard. On the 2001 Gallant 2.4, it is located behind the timing belts. Removal of the main pulley, the covers and the belts is required. This isn't as hard as it sounds and is essentially the same as changing the timing belts. A manual (from Haynes) is helpful. Once the belts are gone, the crank shaft position sensor removal is trivial. Go look in the book and see if you're up to it.
replacing crank shafts
if you have a code w/ cam to crank reference then yes. if only a crank sensor issue the no