behind the harmonic balancer pully on thr right side of the engine
behind the crank pulley
Undecided QuestionShow me another » Where is the camshaft position sensor located on a 1997 pontiac with a 3800 motor
The setting is you better have good eyesight! It has to be positioned between the fins on the back of the cranshaft dampner.
On the 3800, its a simple optical gate, that reads the teeth in a toothed wheel. If you crack open most ball-mice, they work on the same concept.
el sensor esta localizado encima de la polea del cigueñal a una pulgada por arriva de la polea
The 1990 Buick LeSabre oxygen sensor is located on the outside of the air cleaner housing. The oxygen sensor will be on the back side of the housing.
Remove the drive belt, remove the crank pulley (need a special puller for this), remove the plastic shield, and finally remove the two bolts that secure the sensor to the engine. This is all done through the passenger side wheel well with the wheel removed.
Depends on the engine. On the 3.1 and 3.4 it is located on the front of the engine, up top, but below the power steering reservoir. The connector for the sensor is located behind the alternator. On the 3800 it is located in the front cover above the crank balancer pulley.
Right above the crankshaft pully and balancer on the timing cover...
The camshaft position sensor is located behind the water pump pulley. If looking directly at the pulley, it is at about the 10 O'clock position. TechJK ---------------------
check the wiring goig to the crank sensors and check and see if you can adjust the gap on the outside sensor maybe its not properly connected
If you still need to know the crank sensor is located on the front side of the engine mounted just behind the harmonic balancer. That would mean the side of the engine with the belts and behind the big pulley at the bottom of the engine. Hope that helps.