If you are asking if it has one, yes it does. If you want to know where it is, It is on the side of the engine near the firewall, about the middle of the engine near the bottom pan rail.
My 1990 Lumina 3.1 had the same problem and it was caused by the crank sensor.
The speed sensor on a 1990 Chevy Celebrity is on the top of the transaxle on the passenger side of the car. To change it unlatch and remove the wire harness then remove the two bolts that hold it in. The speed sensor can then be lifted out of the transaxle. To reinstall a new sensor reverse these steps.
No crank sensor on a 1990, only the pickup plate (cam sensor) in the distributor. how about a 1991?
It is located on the back side of the engine, where the distributor originally went.
On a 1987 to 1990 Celebrity with 2.8/3.1L engine the crankshaft position sensor is on the side of the block beneath the exhaust manifold on the firewall side of the engine.
There is no 1994 Chevy Celebrity. The Celebrity was discontinued in 1989, with the exception of the station wagon which remained in production through 1990. Assuming you mean 1984, depending on which engine it is, very easy or slightly difficult.
it does not have a crank position sensor. it uses the ignition control module as a crank sensor. it is in the distributor cap
Yes
There is no cam sensor on a 90 3.1. Only a crank sensor.
Dodge Dakota V6's didn't have a crank sensor until 1992.
Inside the distributor
Inside the distributor.