(1995-98) 3800 Gen 2 Three steps: 37 ft/lbs: +130 degrees: + 30 degrees (Center 4 only)
(1999-05) 3800 Gen 2 Two steps: 37 ft/lbs: + 120 degrees
According to the GL-1000 shop manual Cylinder head bold torque is 38-41 ft-lbs.
from a Toyota techfrom a Toyota tech. torque with torque wrench to 38 ft/lbs. then mark bolts with white paint like white out and turn additional 90 degrees. then another 90 degrees
Torque Sequence 1993 3.8 Cougar; Looking at Engine from front of car the lower bolts are 7 3 1 5 upper bolts are 8 4 2 6. Step 1; Torque in Sequence to 37 FT./ LBS Step 2;Torque in Seq. To 45 FT./LBS. Step 3; Torque in Seq. To 52 FT,/LBS. Step4; Torque in Seq. To 59 FT./LBS. Step 5; Back off all bolts in Torque Sequence 2-3 turns. Step 6; Retorque all Bolts in Sequence 11-18 FT/LBS. Step7; Rotate Long Bolts 85-105 Degrees, Short Bolts 65-85 Degrees in Sequence. Recheck final Torque in Sequence. When replacing Head Gasket Besure To Replace all Head Bolts. Hope I Have Helped -u-. "Odie" OdiebuiltMC@aol.com
A sequence of 3 positive integers.
the 38 S&W cartridge is shorter the the 38 special and the 38 S&W cylinder is also shorter the the 38 special cylinder. both colt and S&W make the 38 S&W cartridge or 38 short cartridge..........................
Torque setting for 7.3/6.9 IDI Diesel Connecting Rod Bolts Stage 1 - 38 ft/lbs Stage 2 - 51 ft/lbs Head Bolt torque is in stages, snug/60/90/110 ft/lbs.
The crane is the part that supports the cylinder and attaches the cylinder to the frame.
38 20+3 = 23 23+6=29 29+9=38
34-38 lbs/ft
20
In my opinion no! The cylinder length of the 38 special would be shorter than the cylinder length of a .357 Magnum.
58