0
Did Dennis miller have a falling out with bill o'riley on the o'riley factor?
Wiki User
∙ 16y agoWant this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
What time does oriley auto parts open on Sunday?
Oriley auto parts opens at 9 on Sundays
Who sings the them song to csi new york?
The Who - 'Baba Oriley' (i think that is how it is spelt)
How do you get to the thermostat on 2000 grand am gt?
There is no thermostat you have to by one at Auto Zone, Oriley's ect.
Where was radar oriley from?
Corporal "Radar" O'Riley on M*A*S*H was from Ottumwa, Iowa.
What is the employee discount at oriley auto parts?
95% off everything in store but battery driven trannies
Where can I find a replacement radiator bushings?
Usually dealer only for most cars. Autozone and Oriley BAP or Mearls may have it.
Transmission diagram for a 1992 Nissan Stanza XE?
you would probably have to go to your local, auto zone, oriley's, napa, or pretty much any parts store and purchase the book
How to replace oil pan gasket on a 1996 neon?
hi you have to remove the oil pan then go to autozone or oriley and tell them you need a oil pan gasket for 96 dodge neon then you would place blue siacone on the oil pan ,then you would place the gasket on the oil pan ,make sure that you can see the screw holes ok very easy.
What is the cost to replace intake manifold gasket set on 2001 Chevy Malibu?
The actual part ( the manifold gasket set ) runs about 80-100 dollars ( i called around got some quotes from Napa , Oriley...etc. ) but the main cost comes from labor, and there is a lot of it! You basically have to take the engine apart to get to the lower one. Overall, ( and i jsut had mine changed out two weeks ago ) the cost is around 700 dollars at a Chevy dealership. I have seen prices near and above $1000 from other smaller auto shops.
Toyota Paseo cranks but will not start. it almost fires then just cranks over. did this once before 6 months ago. then got in it the next day and it fired right up. no problems until now. problem?
Well, have you checked to see if you have spark? you can do with by removing a spark plug wire from your distributor and have someone turn the motor over. if it trys to start that means there must be some kind of spark... might consider the timing belt jumping or take it to autozone or Oriley's and ask them to test your ignition control module. if that's not it ...chances are its the coil.
Why would your 1987 Buick LeSabre's engine cut out when you put it in Park and now the car will not start although power comes to lights radio etc when the key is turned?
I have the same problem with a 1993 Buick Le Sabre. We can not find anything wrong. I have the same problem with a 2000, no "check engine" light come on and no codes show up. Does anyone have any answers? Engine cut out in park: HAD SAME PROB ON `90 WAS CAM SENSOR, COMP DIAGNOSED IN 1MIN FLAT. IF CHK ENG LIGHT IS ON TAKE BY ANY PEP BOYS/ HILO ORILEY AND THEY MAY HAVE OLDER COMPUTER (AUTOZONE ONLY HAS COMP FOR `96 OR NEWER) & IDENTIFY PROBLEM FOR FREE. OR TRY LOCAL USED BUICK DEALER PARTS DEP. SOME ARE VERY HELPFUL (FREE) SOME ARE NOT ($) BUT ANY CAN ANSWER Q IN DETAIL (SAME GOES FOR NO LIGHT BECAUSE LIGHT MAY BE OUT IN DASH OR COMP UNABLE TO TRIGGER. I WOULD STILL GET COMP CHK ANYWAY.
Where can i get owner manuel for a 1987 komfort 31 motorhome?
I went to ORiley's (aka Kragen) and got a Chilton 1987 thru 1997 GM book, Motorhome was quoted on the front cover. It covers the engine on the p30 chassis. BUT, I am still in search of a owner manuel for my 87' 28 ft Komfort MH. I DID find a BATTERY DISCONNECT Service Manual off of http://intellitec.com/techsupp2.htm as a PDF and printed it out (9 pages) Its about the battery switchs and solenoids, w/ a wire diagram. I had prob with the coach batt switch. 2 new batterys, nope. no continuity for ON w/ the coach switch. found a local guy that HAPPEN to have a new switch, installed it and both chassis and coach switch WORK independently. no more flashlights or starting the eng to have 12v lights. lol. course you have to get the whole switch, not just a rocker switch, they are soldered into a electirc board, paired and then plug into a 10 wire flat plug. In the end i think we are gonna have to find specific websites like Intellitec to piece together the parts of the motorhome with PDF printouts. Good Luck.
