0
Didn't tag wires while changing stater relay on 1988 ford bronco---what next?
Wiki User
∙ 17y ago
So you're just looking to reconnect the starter relay? First make sure the negative (-) terminal is disconnected. Next, there should be 4 connection terminals on the relay, 2 big and 2 small. Connect the cable coming from the (+) battery terminal to one of the big terminals on the relay. Connect all the smaller wires that have a washer like connecter to the same terminal and screw on the nut to hold them in place. Next connect the big cable running to the starter motor to the other large terminal and screw on the nut to hold it in place. There should be one more small wire with a female type connection - slide this wire on to the small terminal on the relay labeled "S" and reconnect the negative cable to the battery...you're done.
Wiki User
∙ 17y ago
Add your answer:
Earn +20 pts
Where is the Stater Relay on a 2002 vw beetle?
fuse box
Where is stater relay on 1977 Cadillac located?
It does not have a starter relay. It has a starter solenoid mouted on the starter which serves a similar purpose.
Where is the stater relay switch for 1993 Mitsubishi diamonta?
It is behind the passenger side glovebox.
Does 1977 Cadillac have stater relay?
No, has a starter solenoid mouted on the starter which serves a similar purpose.
Where is the starter relay on a 1989 Honda civic dx hatchback?
The starter relay should be under the hood or under the dash depending on if you have had a swap or not. Another cause that will relate to a stater relay would be the 12 volt main relay. If your car cranks but has no spark then theres a really good chance your main relay is bad or is going out.
Location of starter relay on a 2000 mercury mountaneer with selonoid on stater?
In your Power Distribution Box , in your engine compartment , ( RELAY # 6 is the STARTER RELAY ) - Ford recommends disconnecting your battery cables before servicing anything in the PD BOX because it's " live "
Why does the starter stay engaged on ford 460 motorhome?
If your starter stays engaged it is either your stater relay (solenoid) or your ignition switch.It is usually the relay,either mounted on your inner fender(earlier system)or on the starter itself.Follow the positive cable (red) from your battery,if it goes directly to your starter it is the later system.To test disconnect the ignition wire on the relay,the small gauge wire.If there is 2 small wires on the fender mounted relay you can disconnect them both if your not sure witch is ignition wire.Leave the 2 large wires connected.If it still is turning over it is your relay,if it stopped it is your ignition.If you have the stater mounted relay remove the small wire from the "S" terminal,and repeat as above.
Where is the exact location of an stater relay in 93 Lincoln Town Car?
Here's how to find it without any miscues. Follow the large red cable from the battery - the little black box that connects to - that's your starter relay! Good luck.
After replacing the starterand stater relay my jeepcj5 83 still makes a crackling burning sound when key is on and clicks when you try to star why?
the batterys are probrably crackling, check your wiring
How do you test the radiator fan relay in a 1993 Volvo 940?
by changing it.
Where is the starter relay on a 1984 Corvette?
I would think that 1984 starter construction, should be very similar to my 1981 starter. The stater relay is set of contacts contain within the Solenoid that is mounted on the side of the stater. Typical solenoid wiring configuration is one large gauge wire (usally coming directly from the battery) and two small gauge wires. The one small wire on the "S" terminal applies power and activates the solenoid when you turn the key, closing the starter relay contacts within the solenoid and applies battery power to stater motor, causing the engine to turn over (crank). Assuming the ignition system is functional and the engine is mechanically operational the engine should run.
1995 Toyota SR5 pickup and the starter won't turn over. where can i get a wiring diagram or help on this I have checked the stater and relay but still won't turn over?
http://personal.utulsa.edu/~nathan-buchanan/93fsm/index.html
