No you don't have to take anything off. Just lift up the hood. look up, and on the back of the headlight you can simply twist off the round part that the bulb is attached to. Take out the old bulb and pop in the new one. It took me about 2 minutes in the Canadian Tire parking lot, and I'm a girl. Make sure you don't touch the new halogen bulb with your hands as the oil from you skin is bad for the bulb. I just used a tissue.
Open the trunk, look for some plastic nuts, remove these and remove your rear lens assembly; remove sockets from assembly.
remove side inner panel and remove the nuts and assembly will come out
how do you remove the turn signal assembly on a 1989 Pontiac Bonneville
Open the hood. Near the front of the turn signal assembly there is a Phillips head screw. Loosen but do not remove the screw; it releases the front of the assembly. You then need to pull forward to release the pin holding the rear of the assembly. Reverse the above to replace the assembly.
Remove the headlight assembly above the bad bulb to gain access to the burned out bulb. To remove the headlight assembly, open the hood, locate and remove the two tabs that lock and hold the assembly in place, with those tabs removed you can wiggle the headlight assembly out in the open. Now you can reach in and r & r the burned out signal bulb
look in your owner's manual
Reach behind the bumper of the 99 Cavalier. There are two nuts that hold the turn signal assembly in. Remove the nuts to take the assembly off and replace it.
Open the hood, remove the two tabs that lock the headlight assembly in place, remove the headlight assembly, doing this will give you access to the signal light socket for bulb replacement.
Remove the headlight assembly above the faulty signal bulb. This will give you access to the signal bulb socket. To remove the headlight assembly, open the hood, stand in front of the headlight assembly, notice two black tabs sticking up behind the headlight assembly inside the radiator support. Pull up and wiggle the tabs to remove them, this will release the headlight assembly. You can now wiggle the headlight assembly out to gain access to the signal bulb socket for replacement.
To replace the headlight bulb in an S type Jaguar, you will first have to remove the plastic cover across the top of the assembly. After moving the turn signal bulb assembly out of the way, you then remove the second plastic cover from behind the assembly and replace the bulb from there.
rear you use a torx driver to remove taillight assembly screws. them replace bulb.
Open Êthe hood and release the light assembly. Remove the socket at the rear of the lens assembly. Press down the bulb gently, rotate it counterclockwise and remove it.